Would comment extensively on the following?
The time is a fact for X-ray inspection. If you set the contrast, tilting angle correctly (provide you did enough cross section to know the few type of failure mode: e.g. smaller balls, shorts, missing one, etc.) you can use only few second to inspect using X-ray (if you are really good, fraction of a sec.). A lot of "leg work" has to be done prior to set up inspection in order to minimize the exposure time. (use dummy parts to figure it out first ... take few photo as bench mark example ... train the operator, etc..it is a massive undertaking)...
This message was posted the OnBoard Forums
reply »