Heller 1707 MKIII
Model: |
Heller 1707 MKIII |
Category: |
|
Model Year: |
2015 |
Condition: |
|
Location: |
USA |
Offered by: |
|
| Contact Supplier |
1707MKIII Ultra Low Power Consumption Reflow Oven with:
- Balanced Flow Heater Modules
- Electrical Operation 208/240 volt, 100 Amps
- Edge Hold Conveyor (Power Adjust) with 4.8mm or .187” long EHC Pins - Front Rail Fixed
- Automatic Lubrication System for Edge Hold Conveyor
- Electrical Interface Up and Down Stream
- Battery Back-Up of Computer, Controller & Edge Hold Conveyor
- Heller Industries CPK Monitoring & Profiling System Integrated into the Heller Reflow Oven
Model 1707MKIII
100% Forced Convection Reflow Oven with the following features and benefits:
· 18" Wide Mesh Belt Conveyor to accommodate PCB's up to 18" wide
· 18” On Load Conveyor and 18” Off Load Conveyor
· 73" Heated Tunnel Length · 1 Internal Cooling Module with 15” of Cooling
· 14 Independent Temperature Controlled 350°C Balanced Flow “Lead Free” Heating Zones
· Spike Zone Design for minimal liquidus time
· Complete Computer Control System including:
· Flat Panel Color Monitor & keyboard Arm support
· PID temperature control to ensure zone temperature stability to +/- 1°C
· Signal Light Tower to indicate system status
· Power controlled Clamshell Hood Lift · Single exhaust port for easy facilitization
· 208V, 60 HZ, 3 phase, 100 AMPS per phase · Left to Right Conveyor Travel
· Enhanced Frame Design · Breaker Over Current Protection
Company Information:
