Electronics Forum | Wed Nov 10 15:10:15 EST 2004 | Marc
ECM out of France has a nice system from what I have seen. thanks
Electronics Forum | Mon Mar 23 16:28:14 EDT 2015 | aqueous
Dendritic growth is always a result of three combined factors: Conductive/corrosive residues Electrical current Moisture A wave solder process normally applies a higher volume of flux than a printed process. Flux however is not the only source. F
Electronics Forum | Wed Aug 22 21:11:38 EDT 2001 | ksfacinelli
We have utilized the ERSA Scope for over one year. Our experience is that it is an excellent product in evaluation of problematic assemblies. It takes a little bit of time getting dialed in on the equipment but once you have it mastered it can see
Electronics Forum | Tue Jan 30 08:51:44 EST 2007 | Machinebuilder
I am in the mid-Atlantic US. I need to solder PCB's to a large copper heatsink. Does anyone know of local (or not so local) ECM's with vapor phase capabilities? How about induction? Thanks!
Electronics Forum | Tue Feb 27 11:38:57 EST 2007 | Brandon
Does anyone know of a company that will come out and perform a Free Onsite ESD Evaluation??? I was given a contqact once, but I lost it. We are an ECM in Austin , Texas. Thanks, B
Electronics Forum | Mon Dec 20 10:20:14 EST 2010 | 18424
Test Resistance to ECM shall be 65C +- 2C @ 88.5% +- 3.5% All SIR Measurements shall not exceed 100 MOhm. I am not sure of voltage.
Electronics Forum | Fri Aug 23 02:47:03 EDT 2019 | sssamw
Even 93% humidity, it will has no condensed water film inside or on PCB, it will have no ECM or CAF, for such consistent 40℃ temperature.
Electronics Forum | Mon Jun 24 22:39:25 EDT 2019 | sssamw
yes, the void should not expose the conductor or bridge the conductor, the coating there should be thick as IPC required but you need minimize the voids and bubbles. ALso for those small chips, a void or bubble on it means possible ECM, normlly shou
Electronics Forum | Mon Sep 04 17:47:07 EDT 2000 | SERDIA ELETRONICA INDUSTRIAL
We are an ECM located in southern Brazil specialized in low and medium volumes and high mix. We also do chassi assembly. You can reach us through the address above or phone 55 41 3334655 Our site www.serdia.com.br is only in portuguese at the moment
Electronics Forum | Fri Jun 07 05:08:08 EDT 2019 | gregoryyork
Does look like delam, if its that bad and the board looks like its HASL finish or Silver, it could also be porous absorbing the chemistries of HASL or Nitric from the Silver which will greatly encourage ECM or poor SIR figures or just simply eat the