Panasonic servodrivers in Tenryu

Subscribe to Thread

Dear friends, I need to retune servodrivers Panasonic MSD5A... - Mar 29, 2013 by Libor Kavan

Wow, that takes me back... I think I have a copy on an old ... - Mar 29, 2013 by isd.jww

I found two versions, a very old one (DOS) and a newer one t... - Mar 29, 2013 by isd.jww

Waw,you are really fast!!! Thank you very much, I am going t... - Mar 30, 2013 by Libor Kavan

Thank you very much, you are an angel, DOS software works wi... - Mar 31, 2013 by Libor Kavan

Libor Kavan

#68577

Panasonic servodrivers in Tenryu | 29 March, 2013

Dear friends, I need to retune servodrivers Panasonic MSD5A3P1EA in my Tenryu MT5530. Some Z axis servo loops are unstable. But I cannot find old Panaterm software for DOS which should be able to communicate with these old drivers. Can you help me? Panasonic support cannot help, it is too old. Thank you very much!

reply »

isd.jww

#68578

Panasonic servodrivers in Tenryu | 29 March, 2013

Wow, that takes me back... I think I have a copy on an old computer that I don't have access to right now. It may take a couple days, but I'll try to get it this weekend. If nothing else, I have a contact in New Zealand that should have a copy.

reply »

isd.jww

#68582

Panasonic servodrivers in Tenryu | 29 March, 2013

I found two versions, a very old one (DOS) and a newer one that should run on WinXP. Hope this is what you were looking for.

Attachments:

panaterm.zip
panaterm3.zip [2.7M]

reply »

Libor Kavan

#68583

Panasonic servodrivers in Tenryu | 30 March, 2013

Waw,you are really fast!!! Thank you very much, I am going to test it!

reply »

Libor Kavan

#68585

Panasonic servodrivers in Tenryu | 31 March, 2013

Thank you very much, you are an angel, DOS software works with these drivers! But some servos still shaking and I cannot tune it by decreasing the gain or autotuning :-( Problem is with driver, when I change it servo works well. All drivers have the same parameters. Maybe wrong capacitors in power supply, I am working on it... Thank you very much again!

reply »