Samsung CP20-CV Help

Subscribe to Thread

We are facing with the Samsung CP20-CV the following problem... - Aug 04, 2010 by martingruber

Sounds like your PCB count is set at 2. Many times 0 is set... - Aug 11, 2010 by SWAG

Hello, do you solve the problem? We have the same pick and p... - Aug 16, 2010 by dan_ems

Hello I think I have to define the machine in Stand-alone... - Aug 16, 2010 by martingruber

Hello, If you have a conveyor at the output of the pick an... - Aug 17, 2010 by dan_ems

martingruber

#62382

Samsung CP20-CV Help | 4 August, 2010

We are facing with the Samsung CP20-CV the following problem: wenn we run production the machine stops after the second pcb. No error or system message appears. The only way to go on is go back to the iddle modus, load the program again, go to the run modus and then the machine will made 2 pcb's again. And so on. Can somebody help us? Thanks

reply »

SWAG

#62422

Samsung CP20-CV Help | 11 August, 2010

Sounds like your PCB count is set at 2. Many times 0 is setting for continuous use. Another cause could be that your SMEMA is not working properly with your downstream conveyor and the machine thinks it can't allow another board into the worknest.

reply »

dan_ems

#62441

Samsung CP20-CV Help | 16 August, 2010

Hello, do you solve the problem? We have the same pick and place machine and I think I can help you.

reply »

martingruber

#62445

Samsung CP20-CV Help | 16 August, 2010

Hello

I think I have to define the machine in Stand-alone modus, but I don't know how.

I cn't find how in the manual.

Thanks.

Best regards

M Gruber

reply »

dan_ems

#62448

Samsung CP20-CV Help | 17 August, 2010

Hello, If you have a conveyor at the output of the pick and place machine with SMEMA comunication between CP20 and the conveyor you must have check it SMEMA in setup (Sys Setup / Preferences)like in the picture. If you dont have this type of conveyor leave it not check and all of the pcb will be removed at the end of assembly.

Best regards, Chirita Bogdan

Attachments: