Dek 265

Subscribe to Thread

I have a DEK 265 with error code: motor comms failure.card ... - May 03, 2006 by

maybe 5v fuse already burn and pls check anther fuse also th... - May 03, 2006 by

The fuses are ok and problem still exists. ... - May 04, 2006 by

This is Shenzhen comofaje Tech.co.,Ltd from China mainland ... - May 09, 2006 by Eyry Ren

...Ehhhh?? Mark Fick, If the SMT Splice Clips or Kapton... - May 12, 2006 by Mika

Mark Fick

#41331

Dek 265 | 3 May, 2006

I have a DEK 265 with error code: motor comms failure.card 0, Axis123 fatal error-reinitialize machine during machine boost up

I replaced new card 0 and still get the same error.I have tried to load the mint program but I cannot get program to abort card 0.It will abort cards 1,2 and 3 and if I swop the cards around it will still not abort card 0 even when the card has been aborted in another slot.This has been a re-acurring problem whenever the machine has been switched off,but now the mint program cannot successfully be loaded. Any suggestion would be greatly appreciated

reply »

Nirmal

#41332

Dek 265 | 3 May, 2006

maybe 5v fuse already burn and pls check anther fuse also thks

reply »

Mark Fick

#41362

Dek 265 | 4 May, 2006

The fuses are ok and problem still exists.

reply »

Eyry Ren

#41425

Dek 265 | 9 May, 2006

This is Shenzhen comofaje Tech.co.,Ltd from China mainland We are the Associator of Hi-tech industry Association, so I think we can become your supplier in China. Now we have Four series products:1 SMT stencil wiping roll/wiper special for FUJI MPM DEK MINAMI YAMAHA SANYO and so on ,non woven wiper 2,kinds of SMT Splice tape, Stencil Machine Accessories,�� Joint Tape,��Kapton tapes, SMT Splice Clips 3 anti-static mat. 4 SMT/SMD Cutting tool and splicing tool

If any of them meet your interesting please send messa

reply »

Mika

#41517

Dek 265 | 12 May, 2006

...Ehhhh??

Mark Fick, If the SMT Splice Clips or Kapton tapes does not solve Your DEK-265 motor comms failure problem, maybe try this:

The 5 Volts should be within +/- 0.05 V. and if I remember correctly it must Not be under 4.5 V. We have been through a variety of problems with the cards when the 5 V is not good. There is an adjustment on the power supply for this. While you are at it, check also the remaining voltages like 12V, etc. Please let us know Your status on the machine and if You already fixed it, tell us how. /Sincerly

reply »