Electronics Forum | Sun Feb 04 15:06:20 EST 2007 | Scotty
Profile should have a longer cool soak. Verify as was mentioned all pin/fixture support through out the entire process. Print, Place, pre reflow hand load, post reflow, carriers, ICT, Depanel and FCT. Conformal Coated or Potted? Mylars work well for
Electronics Forum | Thu Mar 15 12:22:13 EDT 2007 | Steve
Hi All! There were a few rigid flex assemblies brought to me this morning with some scratches in the coverlay of the flex. They are pretty minor, but they do go down into some traces a bit. I don't think the traces are really signal traces, but are
Electronics Forum | Fri Jan 30 14:20:55 EST 2009 | scottp
I do a lot of thermal cycle testing of new components for my company and often when I lay out a test board I'm trying to simulate 4 or 6 layer boards but I don't need them for routing so I just use a solid fill of a cross-hatch pattern. I've done it
Electronics Forum | Fri Apr 10 07:52:16 EDT 2009 | davef
On cure checking, we have this undated note from Jack Crawford at IPC * IPC-SM-840C "Qualification and Performance of Permanent Solder Mask" has several Test Methods for different types of solder resist material, but probably the only applicable one
Electronics Forum | Tue Jun 09 23:00:53 EDT 2009 | davef
Suppliers are: * Asymtek; 2762 Loker Ave West, Carlsbad, CA 92010; 800-279-6835 760-431-1919 F760-431-2678 asymtek.com * Ultrasonic Systems; 135 Ward Hill Ave, Haverhill, MA 01835; 978-521-0095 F978-521-7023 ultraspray.com sales@ultraspray.com Stepha
Electronics Forum | Mon Sep 21 21:24:34 EDT 2009 | davef
First, we're not real concerned about gluing induced ESD damage, but conformal coating has a tremendous potential to damage sensitive components. We found a charge of 12 kV generated during the aerosol spraying. Second, ESD-stuff IS very confusing.
Electronics Forum | Wed Jun 30 12:41:25 EDT 2010 | rgduval
In general, if the process has been consistent for a period of time, then one should look at any new variables in the process. Therefore...the supposition that there's a bad lot of components is a very good one. Did Yageo offer any possible explana
Electronics Forum | Mon Feb 06 17:24:26 EST 2017 | westshoredesign
So I had the same question too when I was setting ours up. My lazy (and cheap) solution was: for each program I have a universal path that is used up to the first dispense instruction and after the last one then I covered the surfaces underneath tha
Electronics Forum | Fri Apr 03 08:34:54 EDT 2020 | SMTA-Gregory
We need to be careful with product to avoid introducing a new failure mode, namely corrosion and dendrite growth, especially those running no clean processes! In addition to heat (reflow, wave and some selective soldering processes) killing the vi
Electronics Forum | Tue Aug 25 11:31:41 EDT 2020 | stephendo
yes Once I was using dewers of liquid N2 and recommended switching. I tried using air to the machine so the sensor would let the machine run. Boards went from good to a two inch icicle covering a large area. We went to a wall mounted single stage fi
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835