Electronics Forum | Wed Mar 10 16:19:34 EST 2010 | swag
We have one and it's awesome. No problems & training and install was great. The only problem we have had in a couple years is inconsistent nozzle fountain (lasted a day or two until we figured it out). It was our fault - an operator had mixed hand
Electronics Forum | Thu May 20 17:51:28 EDT 2010 | geocep
ACE sent an engineer from the Factory, and now the process is running much better. We had lots of problems, but in the end ACE never gave up, stood behind their product, and kept supporting until we got the process to work. We are now able to consi
Electronics Forum | Sat Dec 18 08:23:33 EST 2010 | remullis
I experienced warpage on a 7'x 13" long board, unfortunately my oven does not have center support. I use stiffeners on both of the short ends. It fixed my problem. Some of the things I was experiencing with the warpage on the second pass were placem
Electronics Forum | Wed Sep 19 12:27:56 EDT 2012 | proceng1
Are you sure that you are getting adequate nitrogen flow up through the cap? If your pump isn't seated properly, you may have nitrogen escaping. Also, I have two different height nitrogen bases. The shorter one does not allow as much gas to escape
Electronics Forum | Wed Dec 05 09:26:08 EST 2012 | proceng1
I've got four KISS 103s. If you keep up with the pump cleaning and especially keep your nozzles clean on the Lead Free, they are great. The only downside with them is that they are West Coast and we are East Coast, so if I have an issue first thing
Electronics Forum | Wed Jan 23 09:48:51 EST 2013 | markhoch
'hege I agree with you 1000%. I wouldn't be at all be surprised if the previous poster was a used equipment broker. And I'd bet $$$ to Doughnuts that he's got a few used, high end, German built machines lying around that he wouldn't mind unloading.
Electronics Forum | Mon Aug 18 16:24:31 EDT 2014 | g2garyg2
So I wanted to provide up-dates on this process. I contacted the supplier recommended and they do NOT offer the kapton dots on a single row for automated processes. Just sheets, however I did find that Identco offers an 8 mm round kapton dot in a sin
Electronics Forum | Tue Sep 15 11:34:20 EDT 2015 | emeto
Hi Dan, you got the basics, so follow your plan. With these machines the most critical part is the fluxer. Most of the m get clogged easily and should be maintained very good.So if there is any tubing, fitting or other type of connector that might b
Electronics Forum | Mon May 09 13:55:33 EDT 2016 | dyoungquist
Omega Aqua Clean LPH. The flux we use in our selective solder process is Kester 2235. Our process cleans water soluble flux very well if cleaned within 24 hours of the boards being processed. We have sent boards off for cleanliness testing per sta
Electronics Forum | Sat Sep 30 15:11:25 EDT 2017 | gregcr
thanks for the info SWAG. My thought was to use a GSM/advantis like a radial inserter or odd form place machine, after double side SMT. We run selective solder as well. The parts I'm looking to place are snap-in electrolytics and radial inductors.
Global OEM manufacturer of selective wave soldering machines. With a world-wide install base in over 65 countries, we are a global leader in the selective soldering space. Highly customized solutions available in all industries.
Training Provider / Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions
201 N Lively Blvd
Elk Grove Village, IL USA
Phone: 7148533287
