Electronics Forum | Mon Nov 06 11:00:58 EST 2006 | SteveH
What low profile components are you dealing with? We have had problems with cleaning under leadless chip carriers using an aquastorm 200 with Kyzen Aquanox 4520T and the general concensus is that you will not clean under this type of device with an
Electronics Forum | Fri Jan 28 09:03:43 EST 2011 | ldavis
Shannon, We have been using VP for all of our lead free production since 2007. Here are the items I can think of off the top of my head. Pro's - small footprint, minimal profiling needed once machine is understood, oxygen free soldering process, s
Electronics Forum | Tue Jul 13 14:36:55 EDT 1999 | JohnW
| I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick. |
Electronics Forum | Wed Dec 06 07:24:22 EST 2006 | davef
Successful solder paste overprint is a function of the solder paste rheology, solder mask and through hole component stand off. * Solder mask with a high surface energy will permit a larger overprint than a solder mask with a lower surface energy. In
Electronics Forum | Tue Aug 04 11:10:22 EDT 1998 | Chrys
| Hi Stoney, | Justin is giving you some good advice, unfortunately these kinda' problems sometimes call for the ol' D.O.E...otherwise, you could be chasing your tail for a while until you figure out exactly what's causing your problems. | Has
Electronics Forum | Tue Mar 24 20:25:18 EDT 2009 | davef
It is very common to use low residue flux with low-standoff parts. On the other hand, sure you can clean under low-standoff parts. We've talked about this previously. Search the fine SMTnet Archives to find threads like: http://www.smtnet.com/Forums
Electronics Forum | Wed Jul 14 09:26:55 EDT 1999 | Dave F
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
Electronics Forum | Wed Jul 14 09:56:54 EDT 1999 | Wolfgang Busko
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
.gif)
