Electronics Forum | Fri Mar 02 00:21:38 EST 2007 | AMS
Hello, I havea 0.4mm pitch TQFP with heat transfer pad on the bottom side of component. I will appreciate any suggestions with regards to: 1) stencil thickness (Rest of components on board are 0603 passives and few 40 mil pitch IC's) 2) Stencil
Electronics Forum | Thu Sep 17 03:36:47 EDT 2020 | SMTA-64386317
Hi All, Is there any specific control for solder height and volume? Such as 3 mil what will be the height and volume upper and lower limit?
Electronics Forum | Fri Mar 02 16:26:57 EST 2007 | Steve
1- Thickness 0.005" 2- I usually reduce 50% of the thermal pad, but it also depend on original size of thermal pad somehow I have to either create window panel or crosshatch otherwise component wil get wimming during reflow. Hope this will help. Reg
Electronics Forum | Thu Mar 08 18:39:06 EST 2007 | elias67
Stencil Thickness should be .005" A reduction along with cross hatching is a must for the center pad to reduce paste volume as well as to assure even paste deposit while printing on a large pad. With out the cross hatch, the squeegie will most like
Electronics Forum | Wed Jun 17 05:41:04 EDT 2020 | SMTA-Davandran
I have one product which only need print low temperature solder paste on OSP pad. This pad will used for hot bar process. Desired solder paste thickness is 0.10 mm to 0.15 mm. Is any one can advise right stencil thickness and aperture opening for it.
Electronics Forum | Thu Sep 17 15:21:50 EDT 2020 | lpbro
For height, I start +-2mil usually. For 3mil stencils, my lower limit starts at 1.5mil, upper is 5. If the area is chem ethed, I normally add .5 to the stencil height. My default volume is 60 - 160%. Then print specs are adjusted till I see fit, then
Electronics Forum | Wed Jul 25 11:16:34 EDT 2007 | lloyd
Hi Folks, I hope someone can help me, Is the homeplate stencil design (for reduced solder paste) the same for preventing solder balls as it is for reducing tombstones? i.e. the reduction of solder paste under the component termination. I'm trying to
Electronics Forum | Wed Feb 11 08:04:16 EST 2004 | autissier
I'm looking for input from anyone who has experience assembling the LGA package on PCBs. Design, stencil opening, or other requirements are welcoming
Electronics Forum | Sat Dec 16 09:42:41 EST 2006 | Frank
Hi all, Having been designing (3d modelling and programming) stencils and tooling (solderwave carriers,print support etc) for several years I am now investigating whether it would be possible to do this from home. I live in the UK and am therefo
Electronics Forum | Sat Oct 26 08:01:17 EDT 2002 | davef
IIT is a reputable supplier. They will be more than happy, happy to help a newbie get a good product. Continuing, at one level of product design sophistication ordering by remote will provide you with a perfectly acceptable stencil. But on the o
