Electronics Forum | Fri May 25 08:06:19 EDT 2007 | davef
Soldering PTFE boards * Exposure to the high temperatures needed for solder reflow poses no problem of loss of peel strength since the exposure times are relatively short. * There are many different types of PTFE based products that may perform diff
Electronics Forum | Wed May 07 21:20:53 EDT 2008 | davef
Causes of Delamination ["Quality Assessment of Printed Circuit Boards" Lund, Preben; Bishop Graphics 1985 0137450354] The reason for delamination is epoxy starvation in the glass cloth layers or an incomplete curing of the base material. It has been
Electronics Forum | Fri Oct 04 11:34:42 EDT 2002 | Bob Willis
Some additional comments from a paper may be of interest. Baking Printed Circuit Boards - Why and How Baking printed boards prior to conventional and surface mount assembly should not be necessary. Often boards are baked for historical reasons; in
Electronics Forum | Mon Feb 05 17:18:53 EST 2001 | davef
Wha, Nellie!!! Delamination & Blistering IPC-A-600D Although it may occasionally occur because of a severe process breakdown, delamination and blistering occurs as a result of an inherent weakness of the material. Either condition represents a brea
Electronics Forum | Fri Apr 17 21:46:18 EDT 1998 | Matthias Mansfeld
I plan to design a multichip module which contains 1 chip with about 200 pads and 2 chips with about 50 pads, no other components.The whole module shall replace as intermediate solution a single chip CPU in QFP208. Thus, the MCM itself must have t
Electronics Forum | Fri Oct 26 17:01:52 EDT 2001 | davef
We process no Teflon boards. Companies, such as Rogers and Taconic, make laminates of Polytetrafluoroethylene [PTFE] er �Teflon�. Common �Teflon� laminates are: * Woven glass / PTFE * Random microfiber glass / PTFE * Ceramic / PTFE * Woven glass /
Electronics Forum | Wed Feb 25 08:34:00 EST 1998 | Earl Moon
CERAMIC CIRCUITRY Starting with hybrid thick film circuits in 1965 at Sperry Flight Systems, I have been involved with ceramics (usually aluminum oxide) as the substrate material. Then, we developed "multilayer" circuitry (replacing "cordwood" module
Electronics Forum | Wed Feb 25 08:30:44 EST 1998 | Earl Moon
| Happy Holidays All, | I am searching out a vendor (US preferred) who can fabricate a ceramic PCb with etremely fine lines. | Please reply if you are a vendor, or know of one. | Thanks, | Wendy CERAMIC CIRCUITRY Starting with hybrid thick film circ
Electronics Forum | Sun Aug 08 11:15:32 EDT 1999 | Earl Moon
| | Mike, | | | | Got your message and those of others concerning PCB fab supplier evaluation and qualification check lists, etc. I have a severe problem here in WI as I can hardly access the internet, and when I do it is cut off abruptly for no goo
Electronics Forum | Thu Nov 19 08:20:04 EST 1998 | Earl Moon
| | | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave so
