Electronics Forum | Wed Dec 17 07:43:44 EST 2008 | muarty
I have just carried out an evaluation project including Mirtec, MVP, Landrex and Viscom. If you are interested in my findings you can contact me offline. In short though, we found that each had plus points to them. If you could join together the outs
Electronics Forum | Thu Aug 21 14:23:56 EDT 2003 | kenBliss
In order to service your wave solder machine safely, the following needs to be understood. Ladling dross out of the machine and putting it in into a coffee can or similar is not safe and puts operators and other employees at risk. Protecting the se
Electronics Forum | Fri May 28 16:03:10 EDT 1999 | Jeff Sanchez
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
Electronics Forum | Thu Dec 18 13:05:59 EST 2008 | tsvetan
we have omron, before buy I have evaluated lot of other machines, what I like most is the three ring at different angle lighting which allows pseudo 3-d solder joint evaluation and historgams with statistics, you can see out of total solder joints ho
Electronics Forum | Thu Dec 18 14:54:28 EST 2008 | hegemon
We evaluated OMRON, YesTech and Mirtec. Mirtec and Yestech close at #1 and #2. Omron was a little more distant due to programming time required. We are a high volume high mix OEM builder, so speed of programming was a heavier weighted score than co
Electronics Forum | Thu Mar 30 07:52:01 EST 2000 | JAX
First of all you need to show them why this particular machine is a problem. there is alot of things you can do to show this: 1. Keep log of downtime: When, why. 2. Keep track of upkeep expences: annual cost to keep operable. 3. Perform capability a
Electronics Forum | Thu Oct 15 17:17:15 EDT 1998 | Justin Medernach
| I need to install some new lines for high mix low volume products in an already cramp building. Could someone share any info about the machines which give you the best bang for floor space. I need a 2 machine system for placing 0402 to fine pitch,
Electronics Forum | Thu Oct 15 20:21:27 EDT 1998 | Dave F
| | I need to install some new lines for high mix low volume products in an already cramp building. Could someone share any info about the machines which give you the best bang for floor space. I need a 2 machine system for placing 0402 to fine pitc
Electronics Forum | Thu Aug 21 09:05:07 EDT 2003 | davef
Use a cartridge that's approved [conform to OSHA 42 CFR 84] to provide respiratory protection against organic vapors, chlorine, hydrogen chloride, sulfur dioxide, chlorine dioxide, and hydrogen fluoride with a P100 particulate filter which is effecti
Electronics Forum | Fri May 28 15:01:02 EDT 1999 | Tony
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
World Equipment Source has over 20 years experience in Electronic Assembly Equipment. We will resell your equipment by utilizing our global market of associates.
Equipment Dealer / Broker / Auctions
8655 Production Ave Suite B
San Diego, CA USA
Phone: 858-693-1991