.gif)
Electronics Forum | Thu Nov 24 03:31:35 EST 2005 | Al
Thanks for the reply. I was looking to find some technical information on each of the process technologies to help me make a decision on what would be the best solution. I have also been collecting information on various selective soldering equipme
Electronics Forum | Mon Nov 28 11:35:37 EST 2005 | stepheniii
There is also peelable or watersoluble masking. I've only seen the peelable masking used. Not ten minutes ago an engineer showed me a board a customer was having trouble with that they are waveing all the bottom parts. That board should be selectiv
Electronics Forum | Wed Aug 16 16:53:48 EDT 2006 | finalassy
Hello, we are currently running no clean flux on our Jade model pillarhouse selective solder machine and i would like to switch the flux over to Water Soluable. Are there any concerens with running water soluable on these machines? I have heard tha
Electronics Forum | Thu Aug 17 15:13:41 EDT 2006 | samir
I hear Pillarhouse is the "Yugo" of Select soldering! :) Chunks et al is correct that if the innards of the fluxing system are made of non-corrosive mat'ls, you should be okay. I used to deal with the original AT&T Spray fluxers and their spray no
Electronics Forum | Wed May 23 10:40:52 EDT 2007 | ck_the_flip
I was the "victim" of an old soltec wave too, along with their DOS-based piece-of-dung software. We have since replaced it. Generally, I find the European equipment makers very weak in the software department. Good examples are DEKs and Soltecs. A
Electronics Forum | Wed Apr 18 10:05:24 EDT 2012 | dyoungquist
We started with SN100C from the very beginning when we purchased our selective solder machine. It has been working well for us. I can't speak to what happens when changing over to it, but I've heard of many companies using SN100C for selective sold
Electronics Forum | Thu Nov 01 12:58:40 EDT 2012 | bburn
My company is looking to purchase a new selective solder system. We're currently looking at the ACE KISS 205 and the ERSA Versaflow3. I am hoping to get some feedback from anyone who has worked with either of these machines or the companies themsel
Electronics Forum | Wed Dec 20 20:24:45 EST 2023 | ronh22
Looking for some Recommendations for a Selective Solder machine. We currently have a KISS103 no pre heater. We are high mix low volume, so batch is most like best option. I have used Pilerhouse Jade MKII years ago. Wondering what other option pe
Electronics Forum | Fri Oct 15 08:00:09 EDT 2010 | patrickbruneel
What you have is blowholes. Baking your boards prior to soldering will help. Root cause is either barrel plating too thin or barrel cracks allowing laminate moisture to escape. Patrick
Electronics Forum | Tue Nov 27 10:26:22 EST 2007 | ck_the_flip
Alot of that depends on your designs as well. Poor designs with lots of DFM violations WILL require a full-time tech./engineer, whereas with good designs, a conscientious operator (who regularly cleans the nozzles) should be good enough. As Chunks
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, USA
Phone: 18002796835
