Electronics Forum | Wed Sep 21 16:25:43 EDT 2005 | GS
IPC-7525 tells you how to make stencil apertures for BGA IPC-7095 tells you how much should be the paste volume in order to get a reliable BGA solder joint. How are your PCB finisced? (HASL, ENIG, OSP, etc?) In case of not HASL, it could be necessa
Electronics Forum | Wed Dec 14 23:32:19 EST 2005 | jhernan9
Hi, I'm having a lot of problems with BGA's shorts, we are using 0.005" stencil aperture 1 to 1 (0.014)", the paste is centre (I can not measured the height)was verified using electronic microscopie, the placement is centre (I'm using local fiducials
Electronics Forum | Thu Mar 29 14:55:59 EDT 2007 | HOSS
Hello, I searched the forums and found little specific info on LGAs with interior lands. This is not a QFN with a center pad. This is a multi-row BGA without solderballs. I'm looking for recommendations on PCB land to part land ratio, stencil a
Electronics Forum | Wed Jul 25 10:57:08 EDT 2007 | cecil
Our board layout folks are currently designing a PWB using a 132 QFN. The component is .5mm pitch with .35mm square pads. The component manufacturer recommends the following footprint: .4mm square land .3mm square solder resist 1.why do they spec
Electronics Forum | Thu Mar 25 11:30:33 EDT 2010 | Sean
Hello Rajeshwara, If not mistaken, the 25% solder void specification is for BGA...As I I as know, no specification given to mosfet component yet..I think you are right, I need to look at the stencil aperture in order to reduce the air trap underneat
Electronics Forum | Fri Jun 11 03:14:03 EDT 2010 | muarty
Thanks Dax, We currently employ a stencil aperture design pretty much similar to that you describe. And you are correct in what you say about the thermal demands almost dictating the allowable voiding level. We have suggested to our customer that th
Electronics Forum | Tue Sep 14 02:46:17 EDT 2010 | grahamcooper22
Hi Gani, Looking at the pictures in the report it looks as if there is a thin coating of solder on the pcb pad....but it looks like the BGA sphere was barely in contact with the pad. This could be caused by insufficient solder paste on this pad...may
Electronics Forum | Fri Nov 14 04:33:42 EST 2014 | slouis2014
Need some help, i'm just new with design and I need to know what software is out there that can answer all my question: able to generate/create correct stencil aperture; Can modify/ edit or redesign the main file(ODB++, Gerber, etc); Can generate cen
Electronics Forum | Thu Dec 20 09:50:44 EST 2018 | stephendo
Once a long time ago I had a board where the cap beside a tantalum shifted in the oven. I phoned our HQ plant and was told that they had the same issue and that it was the tantalum capacitor outgassing. We just applied a dot of glue to the cap. Try b
Electronics Forum | Tue Oct 15 17:54:08 EDT 2019 | davef
From J-STD-001: Components designed for pin-in-hole application and modified for butt connection attachment, or stiff-leaded dual-inline packages (e.g., alloy 42, brazed or tempered leads) may be modified for use on Class 1 and 2 products but shall n
