Electronics Forum | Wed Apr 19 11:50:05 EDT 2006 | amol_kane
Hi BJ, Everyone's favourite answer...it depends! If the volume if large, masking boots will save you both, time and money in the long run. Custom boots are relatively expensive to buy, but they pay themselves over time by savings on masking tape. ma
Electronics Forum | Wed Mar 27 01:06:12 EST 2002 | ianchan
Hi Guys, We are using two types of support Jigs for our PCB boards, during the paste printing, chip shooter, and IC mounting. The two types of support Jigs are : 1) "self-fabricated" aluminium support Blocks 2) "off shelf purchased" support Pins T
Electronics Forum | Sun Feb 05 13:41:47 EST 2006 | bvdb
We recently purchased an old Fuji IP-I placement machine and have been testing 8x4 feeders for 0805 parts, etc. I have opened some of the non-working feeders to replace broken pieces and have noticed that some of the feeders are completely clean ins
Electronics Forum | Fri Mar 20 10:31:19 EST 1998 | Mick Jones
| I will be starting a conformal coating process soon, I am looking for any pointers on | 1) Best method for masking components, tape mask, liqued mask | 2) Which is best Spray or Dip? | 3) Compatiblity with no clean solder paste (flux residue) | I h
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
