Electronics Forum | Mon Feb 07 14:25:43 EST 2011 | rodrigo
Hi all, This machine is pretty good. Thanks to all that have been helping me out with this. I have another question ... Some PCB have footprints that are a bit larger than the actual part (0805, 0603) so they move when they go through the reflow ove
Electronics Forum | Mon Feb 07 18:12:56 EST 2011 | eadthem
I do not know what software version you have, but on older versions it is best to have a mounting inspector set to be the primary and then mask out all labels and solder so it just locates the part. Then add another mounting inspector for looking at
Electronics Forum | Thu Feb 17 18:15:57 EST 2011 | rodrigo
Hi All, Does the Inspector software have a library manager? I see a "Standard" and an "Alternate" library folders. The standard library shows the outline (like a footprint) for the components but the alternate library has pictures and outlines with
Electronics Forum | Sat Mar 05 22:53:47 EST 2011 | rodrigo
I don't remember seen any settings for the marker in the board options. But then again I can't remember where the board options are. I haven't turned on the machine in like a week. I haven't really checked if the marker moves when I zero the machine
Electronics Forum | Wed Apr 23 10:19:53 EDT 2008 | mikesewell
Has anyone tried to increase the working height on their Mirtec AOI. We have several MV-2HTL machines and have a few boards that are over 2" tall. I'd rather not leave the parts out and have a secondary step to install them after inspection. I've
Electronics Forum | Tue Jan 25 19:50:19 EST 2011 | bdamico
Hello Rodrigo, You are running a very old verson of software. The MIL library is also out of date. I think your organization should reconsider purchasing MIRTEC's second owner support package. MIRTEC charges a flat $6,000.00 fee plus travel expe
Electronics Forum | Thu May 03 15:03:47 EDT 2012 | rodrigo
Hi, We got a used Mirtec MV-2HTL. I was able to sort of get it to work without any training. Their software seem well design and it did find the same errors the human inspectors were finding. But be aware that you have to register with Mirtec if you
Electronics Forum | Tue Apr 01 16:14:37 EDT 2014 | emeto
Hello, I have newer generation machine(MV-7) and in my software I can open two programs at the same time. After you do that there is a button in the software saying T/B. when you press this button it will run board1(or top side) and right after you
Electronics Forum | Wed Jan 19 12:54:17 EST 2011 | bdamico
Hello Mark, The centroid data you are currently using to program the MV-2HTL may be used with either platform. However, the libraries cannot be shared due differences in camera resolution. The MV-2HTL will have a 1.3 megapixel camera versus the 2 m
Electronics Forum | Mon Apr 23 22:27:14 EDT 2012 | padawanlinuxero
I have a MV-2HTL and we don't have problems with it. Have you try to contact Mirtec ? probably is a problem with the camera.
