Electronics Forum | Wed May 27 13:42:08 EDT 1998 | Chrys
| R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recommen
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Fri Jan 12 10:05:52 EST 2001 | Charlie
What has been your experance with fine pitch parts taped and reeled? Will I have lead problems?
Electronics Forum | Wed Feb 24 11:00:12 EST 1999 | Steve Schrader
Are the terms "uBGA" and "Fine Pitch BGA" synonomous, different all-together, or is Fine Pitch BGA a subset of uBGA? Thanks. Steve
Electronics Forum | Sat Nov 13 14:09:45 EST 1999 | se
First, let me say what I always say: a good chem-etched stencil will print fine pitch. Chem-etch brings trap to the side walls because its a physical by-product of the process. Because they are less expensive you can add electropolish and still save
Electronics Forum | Thu Jul 18 17:41:31 EDT 2019 | rgduval
The UFP was a designation for "ultra-fine-pitch"; but, for the most part, you should be able to get the same placements out of both machines. Anything 0402 or above can be mechanically centered. The UFP machine will lean on optical centering for .5
Electronics Forum | Tue Mar 14 21:09:20 EST 2000 | Dave F
Emmanuel: Take Jax's word. NiAu (ENIG) primary (some would say only) redeeming characteristic is its flatness that you mentioned, but that flatness appeals to folk placing fine pitch devices, rather than BGA. Good luck. Dave F
Electronics Forum | Fri May 07 02:27:57 EDT 2004 | Grant Petty
Hi, They do what we need component wise, however I was wondering if anyone had info on reliability, ease of programming. We are looking XP 142 and 242 series chip shooters and fine pitch placers. Regards, Grant Blackmagic Design
Electronics Forum | Tue Mar 14 21:09:20 EST 2000 | Dave F
Emmanuel: Take Jax's word. NiAu (ENIG) primary (some would say only) redeeming characteristic is its flatness that you mentioned, but that flatness appeals to folk placing fine pitch devices, rather than BGA. Good luck. Dave F
Electronics Forum | Mon Jul 15 17:35:42 EDT 2002 | davef
Micro BGA � (�BGA�). A Tessera brand name for a fine [0.5 mm and 0.75 mm solder ball] pitch BGA.
.gif)
