Electronics Forum | Tue Dec 10 20:42:43 EST 2002 | davef
Vijay, Sounds like you're not spending enough time at liquidous plus 20*C. And you need to stay there for 5 to 10 seconds. I know, I know. We have used bucketsful of WS609 over the years. See, as you say, the melting point of your solder alloy
Electronics Forum | Fri Feb 28 01:08:33 EST 2020 | sarason
Back in the 50's, 60's and 70's gold plated boards were all the rage for high reliability. test equipment, milspec etc. Nowadays only edge connectors are gold plated. Immersion plated gold is also used but it doesn't last the distance like gold plate
Electronics Forum | Fri Feb 28 00:42:40 EST 2020 | luciano_zhang
What is the use of gold plated boards?
Electronics Forum | Sun Dec 13 08:49:15 EST 1998 | Ron Costa
Has anyone had any experience with using this alternative plating process? Some board houses are pushing toward this plating. Is there any long term data on this process? Any problems experienced with smt and thru-hole? I've heard tin whiskers to be
Electronics Forum | Wed Jun 29 16:25:51 EDT 2005 | mattkehoe
When discussing this with the customer he said that his vendor recommended a hard gold plating finish on the board due to the BGA. I said "hard gold"??? And he said yes, hard gold. Turns out the boards were plated with hard gold, not ENIG. Thank
Electronics Forum | Tue Jun 28 09:39:00 EDT 2005 | davef
Points to consider are: * Gold plating too thick [SB LT 8 uinches]. [Obviously, we're talking about actual plating thickness, not the specification.] * Reflow recipe improper [SB 220*C 5-10 sec]. A recipe that works fine for HASL needs to be hotter
Electronics Forum | Fri Feb 28 01:36:43 EST 2020 | crystal12
> What is the use of gold plated boards? <BR> <BR> With the increasing integration of IC, the more IC the more dense. The vertical tin spray process is difficult to flatten the pads, which brings difficulty to the SMT mounting, and
Electronics Forum | Mon Sep 11 20:33:25 EDT 2000 | Dave F
What does a section of the through hole look like? Is you fab using a dull drill and plating over the fibers? Good luck
Electronics Forum | Tue Aug 11 15:13:05 EDT 1998 | Xingsheng
Hi, can you please tell me how to make green coating and through-hole plating of PCB? Thanks! Xingsheng
Electronics Forum | Thu Oct 21 16:31:23 EDT 2004 | Tony
I have a component manufacturer that is using Sn/Ag/Cu plating on chip caps and resistors. Does anyone have any information on compatability with Sn/Pb paste. Are any changes in profile required? Is the reliability of the solder joint at risk? Tony