Electronics Forum | Fri Jan 25 13:41:04 EST 2013 | dontfeedphils
You definitely have to be careful with unsealed components and markings/labels. The best you can do is check with datasheets or find an extra assembly to test it out on first. You can also try slowing down your inline to more like 1-2 ft/min and se
Electronics Forum | Fri Jan 25 15:51:26 EST 2013 | johng
Water soluble process, yes. The machine is old and fixed at 4 ft/min by someone way before me. Looking into ways to reverse that to allow for adjusting the conveyor. Trying to determine how the contamination gets onto the boards. So far testing has i
Electronics Forum | Thu Dec 21 06:10:10 EST 2023 | jillclifton
Any update?
Electronics Forum | Wed Feb 19 06:16:53 EST 2014 | cunningham
Yeh due to the solvents in the coatings im guessing there is a health and safety risk. Solvent stripping is a lengthy process for the coatings we use and usually means submerging the whole board so not local to the rework. We have a booth with ioni
Electronics Forum | Tue Oct 24 20:50:41 EDT 2023 | dilogic
Can anyone recommend machine for conformal coating? I know that it depends on the coating material, but I am interested in practical advices - like experience with existing equipment, maintenance issues etc. Thanks in advance. - Deni
Electronics Forum | Mon Jan 26 11:41:04 EST 2004 | pbarton
Some questions: Is the peelable/spot masking only being applied to the earthing points on the one side or to both sides? Is the peelable mask you are using specifically designed for coating masking or is it the same as that you use for masking sold
Electronics Forum | Wed Jun 29 14:36:11 EDT 2005 | Steve
A customer of mine is using Chemtronics (Circuit Works) CW3300 Overcoat pen. This is an acrylic conformal coating. It cures at Room temperature. They need something similar that can be UV cured in a pen form. Any suggestions?
Electronics Forum | Mon Apr 23 14:36:41 EDT 2007 | ck_the_flip
Sorry to interfere with Dave F, but perhaps your IAg finishes have issues with process residues from the boardhouse. What is the base material of your ConAP conformal coating - acrylic, silicone, polyurethane? We do CC (acrylic) and IAg and never h
Electronics Forum | Wed Sep 09 17:24:49 EDT 2020 | kumar
For Conformal coating machine to mask the components which material(silicon or SS) make masking boots is beeter interms of Cost,cycle time,Reusable lifecycle
Electronics Forum | Fri Jan 25 13:07:31 EST 2013 | johng
Thank you for replying Phil. We use water only wash at 130°F and at 4 ft/min (about 2 min). They are mostly dried by the hot ait knife and left to air dry until next day. The operators do not wear gloves. When I run a bare board through the same pro
Lewis and Clark is your #1 Pre-Owned Surface Mount and In-Circuit Test equipment supplier. We offer a variety of equipment solutions at a significant cost savings over new.
Manufacturer / Equipment Dealer / Broker / Auctions
18 Celina Ave., Unit 16
Nashua, NH USA
Phone: (603) 594-4229