Electronics Forum | Sun Nov 05 23:01:53 EST 2006 | Sxsxcx
ok, sorry ,750 was deg F and which I said 350~400 were deg C, I got a mistake. As I know, we use 660~720 deg F to do reworking for lead free solders such as SAC series and SnCu0.7 series solder to protect irons and components on boards. when temp.
Electronics Forum | Tue Nov 21 12:35:59 EST 2006 | CK the Flip
It probably depends on the Silver content. We are also using Sn62Pb36Ag2. The paste manufacturer told us that the reason for the small silver content was so that it could wet better to the lead-free component and board finishes bearing silver.
Electronics Forum | Mon Dec 04 11:46:41 EST 2006 | samir
SMTNetters, I have a product coming down the pipeline that we'd like to make pure double sided reflow, it'll be RoHS product, and the hope is... we'll be able to solder the thru-hole stuff by screen printing solder paste and reflow soldering. Anybo
Electronics Forum | Mon Dec 18 16:13:15 EST 2006 | darby
AJ, No overprint. We have components in very close proximity that precluded that. Also we have differing areas of thermal relief for the pads from a large backplane, from none at all to open blocks to individual pad relief. After a few more experimen
Electronics Forum | Mon Feb 05 07:02:11 EST 2007 | CL
ASIR, Findings for us so far: OSP- has worked well for us for single sided boards only. We have seen problems with using it on double sided reflow applications. Also, some customers have specified OSP, but are intolerant of exposed copper. Limited
Electronics Forum | Tue Jan 30 12:16:47 EST 2007 | pbarton
We are seeing unusual soldered joints when soldering to components with Pt/Ag metallised terminations. At the margin between the bottom of the component termination and the PCB surface there are a number of blowholes in the bulk solder. There also ap
Electronics Forum | Fri Apr 06 10:43:57 EDT 2007 | flipit
Hi, Anyone seeing difficulty is soldering MLFs or QFN with lead free solder? I have an MLF with 3 rows of pads on each of the 4 sides of the part and then the large center ground plane in the middle. The part is 20 mil pitch. Had good luck with l
Electronics Forum | Thu Apr 19 16:54:32 EDT 2007 | flipit
I don't suggest using Pd/Ag or Ag/Pd terminated components unless you are forced to use them. You often see a line of demarcation that suggests a poorly wetted solder joint. I have had bad experiences with Pd/Ag terminated capacitors. Even when so
Electronics Forum | Fri May 25 13:38:15 EDT 2007 | mfgengr
TAL Too Long - dull solder joints, dewetting. TAL Too Short - cold solder, insufficient wetting. You want TAL to be as short as possible (but not lower than 30 seconds), but long enough for every solder joint to be above TAL for at least 30 seconds.
Electronics Forum | Tue Jul 10 11:49:20 EDT 2007 | samir
Parallelism tends to drift: �h After preventative maintenance �h From dross buildup or other obstruction clogging either wave Parallelism should at least be studied during the process characterization stage, so that you know your machine's process
