Electronics Forum | Tue Oct 24 19:09:12 EDT 2023 | sarason
Possibly blocked air lines did you check air pressure? Also drivers on the relevant boards. or simply damage in the flexible wiring harness( a nightmare) sarason
Electronics Forum | Tue Jun 14 15:02:13 EDT 2022 | glasscake
Start with fundamentals: Disconnect, clean and reconnect all inner connections, bulk heads, ext. Disconnect, reconnect all connections at the controller. Check wiring harness for conductivity. Clean everything appropriately, lube ways, balls screws
Electronics Forum | Tue Nov 01 14:38:45 EDT 2022 | glasscake
Did the tray changer use to work on this machine? was it ever disabled and uncoupled from the machine? If you have an old data disk or backup disk of the machine try restoring to that. There is also a jumper inside the wiring harness to include the
Electronics Forum | Thu Nov 10 11:48:03 EST 2016 | awhite
I recently had a similar problem on our 2000Hie, although ours was a 7-Hardware, Vision X. Turns out there was a short/break in the 3-wire harness that controls the Vision X Stepper. The difficulty came from the fact that this particular harness is
Electronics Forum | Wed Jan 17 07:58:31 EST 2018 | lokiz
Greetings, I have been told that auto rail width with the Samsung SM320 is a purchased option opposed to a standard feature. What I would like to know is what all comes in the auto rail width kit. It looks to me like the wire harness where the rai
Electronics Forum | Mon Jul 21 11:01:11 EDT 2014 | dontfeedphils
I dealt with the same issue for a month or so. We jumped through a lot of hoops, replaced both lead screws, verified the motor was good, a ton of stuff. Ended up being an intermittent wire connection between the control board and the conveyor width
Electronics Forum | Sun Dec 26 16:13:49 EST 2010 | sam
Hi, Here is a brief synopsis of PNC - PNC has been a quality manufacturer of rigid printed circuit boards for 40 years. Located in Nutley, NJ, we are the largest shop in the North East. PNC provides complete turnkey jobs from design, PCB fabricatio
Electronics Forum | Wed May 16 18:09:09 EDT 2018 | dleeper
Does the table move under the stencil than just sit there doing nothing? there is an optical sensor in the machine near the end of travel, sometimes solder past or dirt gets into it preventing the contact from being made. Another issue I vaguely rec
Electronics Forum | Tue Jul 29 13:01:57 EDT 2008 | grics
I know your pain all to well. We currently use bmps or jpgs and group them by station (for case assembly) We do this for inspection purposes. Sad truth is most people on the line end up becoming the "sole builder" of the product and decide they ha
Electronics Forum | Tue Jun 15 16:09:02 EDT 2004 | dougt
Our "mechanical engineering dominated" company is allowing the electrical group to purchase some software to produce machine wiring diagrams. The only stipulation is that it has to be low cost. Can anyone throw out any products? I'm not looking fo
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, CA USA
Phone: 5102268155
