Electronics Forum | Tue Jan 15 06:05:37 EST 2002 | Romain
Dear all We have since few weeks problems with BGA solder joint integrity on ENIG finish. Under relatively very flexible of the FR4, the joint breaks between ball and PWB. When we take off the BGA for analysis, some of the pads seem very flat, totaly
Electronics Forum | Tue Jan 15 09:42:40 EST 2002 | davef
Here's two choices. 1 Before accepting a lot of boards from your supplier: * Print some paste on a board * Reflow the paste * Inspect the quality of the solder connection * Make a decision on accpting the board based on that observation. 2 Have yo
Electronics Forum | Mon Jun 12 06:45:10 EDT 2000 | kim ji tae
Hi! Thanks all who upgrade these pages. I have some questions. Is there any answer? I do double-sided reflow solderig, with 0.4% AG solder cream. with AU finished pcb. First I do reflow solder bottom side where 0.5pitch TQFP locates. Second I do re
Electronics Forum | Wed Jul 28 17:34:27 EDT 2004 | Steve Stach
Hi Ralf, This discoloration may be re-oxidation. Fluxes are supposed to do three things (1) remove oxide, (2) promote wetting, and (3) protect surface from reoxidation. The solder paste possibly is not protecting from reoxidation. Best Regards, St
Electronics Forum | Wed Jan 16 20:06:09 EST 2002 | davef
No, not as such. Consider: * Using the IPC calculator [free at http://www.ipc.org]. It allows you to consider / assess the amount of solder when designing pads. * Reviewing IPC-7525 - Stencil Design Guidelines. It gives general aperture guidelines.
Electronics Forum | Wed Jun 14 18:21:23 EDT 2000 | Robert Moore
It has been our experience that the problem you have discribed was not solder process related. We had two such instances in the past and both were component related. The first case involved a PLCC28 that failed test. Reflowing the solder seemed to co
Electronics Forum | Tue Dec 14 10:36:42 EST 1999 | Paul Peterson
I recently encountered reflow soldering defects on a pair diode package, the smd pad had a green contamination, I'm convinced that this is not oxidation. The no-solder condition appears to be caused by a sloppy soldermask process, although over the y
Electronics Forum | Tue Dec 14 11:08:19 EST 1999 | John Thorup
I think you're on the right track Paul. You didn't mention what type of solder mask was used but I'll presume that it was LPI (liquid photo imagable). If development of the image is incomplete some mask can remain where it is unwanted. Sometimes im
Electronics Forum | Mon Jun 12 22:00:51 EDT 2000 | Dave F
Could be. What are your profiles? 2) Au finish fail => Could be, but that the connections can be made with hand soldering makes this a low probability cause, assuming the activity of the flux used in hand soldering is not significantly different fr
Electronics Forum | Tue Dec 14 11:08:59 EST 1999 | Wolfgang Busko
Hi Paul, you got to find the reason first before any measures can be taken. You have to determine wether it happend somehow at your site or at the boardhouse, you can�t blame them without reason. As long as it is suspected that more of those panels
