Electronics Forum | Tue Aug 30 12:08:09 EDT 2005 | slthomas
The answer for us at my previous employer was water soluble flux. Wash the board, no residue. If you're not set up to wash (needing a washer, DI water source, waste treatment, ventilation, etc.) it can be expensive and space consuming. Do some resea
Electronics Forum | Thu Feb 04 09:18:18 EST 2010 | mika
Problem! Then replace the motor! Why not replace be belt anyhow? How long was it since the last time you replaced any belt? Another thing you could also do; In the LP (Low Power) chassis lower front left, find the correct motor servo card and "Null
Electronics Forum | Tue May 31 11:35:12 EDT 2016 | swag
It's a Spectrum Technologies Sienna 300 Series. The main down fall is that you can only program x and y (as far as I know). By that I mean you can't do circles or diagonals. Only squares and rectangles or shapes with only vertical and horizontal s
Electronics Forum | Mon Feb 28 03:46:34 EST 2000 | Hany
Hello 1-In our facility we face a lot of power failures due to the to the city electricity network problems.So, it has hppend many times to loose some PCA's inside the reflow oven. Of course it costs a big money to buy a UPS for a reflow oven. One
Electronics Forum | Mon Feb 28 03:46:34 EST 2000 | Hany
Hello 1-In our facility we face a lot of power failures due to the to the city electricity network problems.So, it has hppend many times to loose some PCA's inside the reflow oven. Of course it costs a big money to buy a UPS for a reflow oven. One
Electronics Forum | Mon Feb 02 12:46:36 EST 2004 | kauer
Just a hunch, pull out and re-seat the cards. also check power supply voltage. We bought 2 used machines and one of them would not boot up, the software would just go in a loop. Turns out the 5 volt power supply was low, 4.85v. just low enough to cre
Electronics Forum | Mon Sep 03 10:57:28 EDT 2018 | robl
Hi Oriol, Sounds more like a power supply/low voltage problem if all the driver cards are failing. Can you check if the PSU supplying them is stable? Rob.
Electronics Forum | Fri May 29 07:17:02 EDT 2015 | anirudh_thabjul
Hiee everyone, I am a Hardware Engineer and also a PCB designer. I am using a Microntroller which is in "CHIP PACKAGE". So in order to connect our microcontroller with my PCB, i am using "Wire bonding Technology". So, Can any one suggust 1. whi
Electronics Forum | Fri Jul 29 17:41:35 EDT 2016 | ddina
I appreciate your response. I kind of read about it, and made sure nothing sensor-wise is activated by mistake on the process of zeroing. Right now the machine is in this set up, and the rear rail is all the way to the back stop. So the sensor on the
Electronics Forum | Fri Jul 30 15:13:31 EDT 2004 | Chris
The Zephytronics unit does not have the power you need. Their process is based on low temp soldering. Companies like PACE have preheat units that will give you more power and control. I see more Zephytronics on the shelf in my travels than any oth