Electronics Forum | Fri Feb 23 16:11:51 EST 2001 | Dave E
The sulphur outgassing from these rubber bands was >enough to contaminate every board... Well, if every rubber band is a threat then sulphur contamination must be a common problem. Are sulphur test kits available?
Electronics Forum | Mon Oct 22 09:32:27 EDT 2001 | Steve L
The solder joint appeared dull and there is dewetting on the PCB after Reflow. The leads of IC we used appeared dull grey before soldering. Dose anyone happen to know if there is a standard to verify the IC contamination and how to deal with the con
Electronics Forum | Fri Jul 22 07:36:18 EDT 2005 | Guest
It's the same like asking wether you get a gold-contaminated solder pot when soldering ENIG boards. As long as the replenishment of dross is large compared to the intake of contaminant, the contamination level will stay within acceptable levels.
Electronics Forum | Mon Dec 26 19:18:49 EST 2005 | arnold
I would to ask on what do you call on the color green contamination found on the soldered units. Whe i soldered some units after few days there was a color green on the wires. what do you call on this contamination?
Electronics Forum | Mon Mar 12 08:27:00 EDT 2007 | rgduval
Have you checked the parts for contamination? Are the voids out of spec? IPC allows some voiding, especially with lead free solder. Component contamination can cause this to repeat, as well. Try pre-tinning the component in question, and see if s
Electronics Forum | Tue Oct 12 13:07:49 EDT 2010 | markgray
Baking of the component helps it depends on the type of contamination and how much contamination. It sounds like your purchasing is buying from brokers.
Electronics Forum | Mon Oct 22 16:47:09 EDT 2012 | edmundo
We use a NC Flux in the wave solder and after aAcelerated Life Test cicle we found contamination white residues paths between some solder points. Does somebody know a possible cause for this contamination.
Electronics Forum | Tue Jan 20 10:00:25 EST 2015 | TM
Hello We are currently cleaning stencils from both process (PbSn and lead free) in the same cleaning machine. A customer is concerned about cross contamination of lead between stencils. Is there any test kit or tool that you can suggest to test the
Electronics Forum | Mon Nov 06 12:43:35 EST 2023 | milas
Hi We are mounting an microphone device (SMT package) onto a PCB which has an ENIG finish and, observed some contamination on the underside of the device, post reflow. The SEM analysis shows that the contamination has a high level of Carbon. Where c
Electronics Forum | Thu Jul 31 23:07:55 EDT 2008 | davef
J-STD-006 lists maximum contamination levels for most solder alloys. This is the basis for purchasing solder. The SOLDER BATH contamination levels in J-STD-001 are based on decades of experience. But these contamination thresholds of various metals