Electronics Forum | Wed Nov 12 04:34:17 EST 2008 | kywl
Hi all, Assuming that i were to design a PCB and there are multiple components, what is the minimum spacing required to ensure that i won't have problems in my SMT process later on? Also, is there a minimum component stand-off height spec as well?
Electronics Forum | Tue Oct 03 11:35:51 EDT 2000 | aaronho
Screen printing has much lower profile than dispensing. So it is suitable for chips without body stand-off, (Even sot23 has stand-off). But is is much faster. Dispensers can not catch up with some chip shooters.
Electronics Forum | Wed Jul 12 21:35:56 EDT 2000 | Dave F
John: I agree. We keep out lead stand-off below 60 thou.
Electronics Forum | Thu Aug 13 10:58:58 EDT 2009 | davef
First piece of advice: build the board as you would any other board. Probably, you will be surprised at the holding force of the solder of the connections of the BGA, because the surface area of the solder is very large compared to the weight of the
Electronics Forum | Thu Apr 05 13:54:18 EDT 2001 | CAL
Do the parts sit directly on the PCB? Typical 2.0 mm Max is desired for the component to be off the PCB. Are stand-offs an option? The long lead wiggles as it passes through the wave and thus agitating the air out.Does your wave a "dancer" option?
Electronics Forum | Fri Apr 06 07:32:33 EDT 2001 | Claude_Couture
Thanks for the tips. I'll have to check with the designers if they can accomodate the height if I was to use parts with stand-off. The bigger holes was already suggested, but they don't want to change them until a new revision on the product comes o
Electronics Forum | Fri Apr 06 07:32:54 EDT 2001 | Claude_Couture
Thanks for the tips. I'll have to check with the designers if they can accomodate the height if I was to use parts with stand-off. The bigger holes was already suggested, but they don't want to change them until a new revision on the product comes o
Electronics Forum | Wed Jul 04 11:07:46 EDT 2001 | a.m.
Hi Mike, What type of component you have the problem? For a quick refernce you have two points for the ideal dot: 1- Dot size = 2/3 of area of glue (pad to pad) 2- Dot height = pad thickness + component stand off
Electronics Forum | Thu Jan 20 12:32:40 EST 2000 | Dave F
Hey Dreamguy: On stand-offs: * "Sugar" stand-offs look nice, after washing (if you wash, as Chad said), but we find them kinda fragile. The only people that can install 'em without bustin' more than they install are the "skill people" that we don
Electronics Forum | Mon May 20 13:48:43 EDT 2002 | sbuckley
What is the recommended prep for a through-hole glass pack diode? Should a stand-off be used or can it lay flat on surface of the pcb?
