Electronics Forum | Thu Mar 03 09:11:25 EST 2005 | russ
I wouldn't raise the temps just slow the conveyor, You need to get the PCB "soaked in". It seems as if you are applying more thermal energy than the PCB can accept in all areas. Does this oven have convection heating? Hopefully so. I have found t
Electronics Forum | Sat Mar 15 20:24:13 EST 2003 | ramanandkini
Thanks Mr.Dave. Sorry for the delay. One of our major prolems in ENIG plated surface is that wire does not stick. For many years we were getting a bond strength of 14 grams in both ENIG and electroplated surfaces. Now one vendor supplies ENIG boards
Electronics Forum | Thu Jul 07 23:43:31 EDT 2022 | tey422
We been using the Sayaka SAM-CT23Q machine to depanel PCB, it was fine. But now, we have to depanel the Aluminum PCBs the current bits from IMPEC we are using are not strong enough (1.5x8.0 diamond downcut). Need to find much strong bit or bits des
Electronics Forum | Wed Jul 27 05:31:09 EDT 2022 | lindsaylbb
Aluminum shreds were found inside the tooling hole after depaneling. We ruled out contamination because the tooling holes were covered during depaneling. Out of three holes, only 2 holes with positioning columns inside have aluminum shreds residue.
Electronics Forum | Mon Jul 11 19:55:13 EDT 2022 | cbeneat
Try Atlantic Micro tools. That is were we get ours.
Electronics Forum | Wed Jul 27 10:52:26 EDT 2022 | madisreivik
Can you post pictures here ? It should be quite straightforward to solve.
Electronics Forum | Mon Jul 11 16:07:27 EDT 2022 | madisreivik
You cannot use diamond cut routers on aluminium. They will clog up in seconds.. You have to use "endmill" type. These are available from all PCB drill/mill supplier, nothing fancy. Depaneling - you mean cutting only tabs, not full perimeter ?
Electronics Forum | Wed Jul 13 17:21:41 EDT 2022 | tey422
I just send a TQ email to Kemmer to find out more about it. Thanks so much for your help!
Electronics Forum | Sat Jul 23 12:41:26 EDT 2022 | madisreivik
If you need to cut longer lengths and chip clogging / evacuation / edge finish is problem, then contact me privately, we have an unique solution for that.
Electronics Forum | Wed Jul 27 17:26:55 EDT 2022 | proceng1
I'm having trouble picturing your setup, but can you put kapton on the columns? Or heat shrink tubing?