Electronics Forum | Sat Sep 18 11:13:12 EDT 2004 | smt
I am in the process of evaluating some pick and place machines. Looking for feedback on Universal's new genesis HSC VS.HSP4797
Electronics Forum | Tue Oct 12 12:17:49 EDT 2004 | mkallen
We have an HSP4797 and can provide a favorable opinion on that machine.
Electronics Forum | Wed Oct 20 11:19:36 EDT 2004 | jax
The HSC, "Lightning Head", is offered on two platforms, Genesis and Advantis. The decision will depend on your throughput needs and price requirements. In comparison to the HSP, I would recomend the HSC. With the ability to use docking feeder carts,
Electronics Forum | Wed Oct 20 15:05:30 EDT 2004 | vickt
18"x24"), Low to high placement count, and need for Modularity tends to lead toward HSC Higher volume, High placement count, Lots of feeder capacity, established horizontal turret solution are all strengths for the 4797 HSP Of course there is overl
Electronics Forum | Sat Oct 22 16:39:24 EDT 2022 | ttheis
We have mid-90's GSM's and we have had to trick the machine in some cases like this by making some of the rail area into board area.
Electronics Forum | Tue Oct 18 07:02:47 EDT 2022 | poly
The product editor complains if I have a part that overhangs the edge of the board. Any hints on how to fix this? Set the "board" size bigger than the actual board and the use an offset to make it in the right place? Or is there a better way to say t
Electronics Forum | Thu Oct 27 13:46:36 EDT 2022 | proceng1
I concur with what Tom said. Sometimes you have to trick the machine. Without seeing your board, I can't offer any specific advice. And I am not familiar with your machine, but we run SAMSUNG machines and between those and several different MPM Pr
Electronics Forum | Fri Oct 28 07:57:31 EDT 2022 | poly
I'd be happy with it just checking if all the pads for placement are on the board. The software (GSM) seems to complain if any of the part is off the board. I got around it by just making the board larger. I'd also like it if it just had a button for
Electronics Forum | Wed Oct 26 22:39:01 EDT 2022 | sarason
This is not really a bug. The logic is this if you place a component beyond the edge of the board, it should falloff! So instead on having a very complex algorithm to work out component centres and then make a judgement as to whether the connector is
Electronics Forum | Fri Oct 28 13:48:30 EDT 2022 | proceng1
Well, I'm not sure about the "Trust me" button. I assume you can't tell it the part is smaller than it is because then vision won't accept it. I often add 10mm or so in X direction. In fact, when I measure the board, I just round the X up, becaus
