Electronics Forum | Thu Dec 23 15:10:50 EST 1999 | Victor Salazar
What we did was design or panels with routed out edges held on by tabs. This was very effective. All we use is a pair of pneumatic scissors to cut off the tabs. We are using from single-to 13 layer PCB's and we have had no problems with delamination
Electronics Forum | Wed Dec 22 11:54:06 EST 1999 | jacob
I was looking at depaneling machines and i need to know the pros and cons of the different technolgies. also I would like to know personal opinioons of which machines are better and more cost effective. thanks jake
Electronics Forum | Mon Nov 23 19:20:18 EST 1998 | Kevin
A buddy of mine has problems after depaneling double sided pre-scored PCB's. Resistors near the edge, after put into the slice and dice machine contain micro cracks. He's checked for them before and after depaneling. We figure it is the sectioning
Electronics Forum | a1customer |
Wed Mar 16 19:56:30 EDT 2022
Electronics Forum | Fri Dec 24 10:51:29 EST 1999 | Bob S
If you have decent volume with high mix or are a contract shop, the most flexible method is a software controlled router. Using pre routed boards with tabs is not a bad way to go but there is a price for the pre routing that may more than justify the
Electronics Forum | Wed Dec 29 12:21:08 EST 1999 | Mike McMonagle
If you go with tabs/mouse bites, both FKN and Cab make simple pneumatic shears for removing the tabs. For low to moderate volumes, they're very cost effective. MikeMcM
Electronics Forum | Wed Dec 22 12:21:51 EST 1999 | Dave F
Jake: This'll get you started: 1 Read the archives 2 primary approaches to paneling are; * Moise bites * Singulation * Routing * Scoring * Shearing 3 Major depaneling technologies are: * Singulation (Wand 708.459.2400fax2421, Circuit Technolo
Electronics Forum | Wed Mar 16 19:59:51 EDT 2022 | a1customer
I do have this machine and I am trying to assess its value https://a1customer.com/products/jot-automation-j501-57-2-laser-depaneling-machine-smt-depanelizers-router
Electronics Forum | Tue Nov 24 11:13:11 EST 1998 | Keith
| A buddy of mine has problems after depaneling double sided pre-scored PCB's. Resistors near the edge, after put into the slice and dice machine contain micro cracks. He's checked for them before and after depaneling. We figure it is the sectioni
Electronics Forum | Tue Nov 24 13:51:23 EST 1998 | Michael Allen
What kind of "slice and dice machine" do you use? I assume you're referring to what I call a score-breaker -- a device to separate the board from the panel (or from the adjacent board) by crushing the score-line WITHOUT bending the panel or the boar
Depanelizer Equipment and Tools For Electronic Assembly. PCB Racks and Trays. Wire Crimp Press and Tooling.
115 Pleasant Street
Millis, USA
Phone: 508 376 2500
.gif)
