Electronics Forum | Tue Jan 21 16:28:02 EST 2003 | tony_sauve
Sorry I didn't close this one off last year... We had some failure analysis done on these PCB's ( 3D x-ray,microsectioning,SEM) and the results definitively proved that there was some contamination @ the base of the uvia's that had the voiding. It ap
Electronics Forum | Wed Apr 16 10:45:16 EDT 2003 | Takfire
Recent cross-section analysis for a customer complaint revealed voiding in the solder fillet. In some cases, the remains of outgassing were also observed. During the failure analysis, we also observed failures where the solder fillet wicked on the
Electronics Forum | Wed Jan 06 09:38:59 EST 2010 | lynn_norman
Via failure could be caused by cracks in the barrel, or thin plating, or fractures in the traces leading to the vias, . X-ray analysis could pick up a fractured trace and cross-sectioning of the vias could pick up the cracks and thin plating. Secon
Electronics Forum | Mon Jul 07 23:27:41 EDT 2003 | MA/NY DDave
Hi Sam, I am going to guess that a problem is being caused by processing to effect the inside of the LED package. Send some failed LEDs back to the manufacturer to do a failure analysis. Also ask the manufacturer for info on their SMT processing q
Electronics Forum | Thu Apr 17 16:43:09 EDT 2003 | davef
Background: * Bulwith, Ronald A., �Failure Analysis of Solder Joints�, �Insulation/Circuits� magazine, February 1978 * Banks, Donald R., et al., �The Effects of Solder Joint Voiding on Plastic Ball Grid Array Reliability�, Proceedings of the Technica
Electronics Forum | Thu Feb 19 12:52:08 EST 1998 | Earl Moon
| what is your experience about the presence of the voids in the joints ? | Are they dangerous and when ? My specifications require rejection and study if voiding exceeds 2% of solder joint volume measured using x-ray and/or x-sectional analysis. My
Electronics Forum | Fri Jan 15 09:27:18 EST 1999 | Earl Moon
| I saw the problem of void in solder bump or in lead less component or some BGA. But I didn't have standard specification of that void is accept or reject? Do any body have the better idea or suggestion of the criteria ? | | Thank you, | Wirat
Electronics Forum | Fri Jan 15 13:35:03 EST 1999 | Terry Burnette
| I saw the problem of void in solder bump or in lead less component or some BGA. But I didn't have standard specification of that void is accept or reject? Do any body have the better idea or suggestion of the criteria ? | | Thank you, | Wirat
Electronics Forum | Fri Aug 06 10:27:05 EDT 1999 | Kenneth Hedman
| | I saw the problem of void in solder bump or in lead less component or some BGA. But I didn't have standard specification of that void is accept or reject? Do any body have the better idea or suggestion of the criteria ? | | | | Thank you, |
Electronics Forum | Wed Apr 21 17:11:05 EDT 1999 | Earl Moon
| Does anyone have any experience with soldering 50mil pitch BGA's that have a via in the pad, the size is .012 The via will be masked off on the bottom side of the board. Need to know what precautions or problems if any I might encounter. The proces
