Electronics Forum | Wed Feb 22 08:02:56 EST 2006 | dj44
I was looking for an stencil design for a 0.5mm pitch uBGA. Pad size is 0.38mm in diameter. We have been using 5mil stencil with type 3 no clean paste. What size aperture should we be using? Any suggestions?
Electronics Forum | Wed Feb 22 10:00:58 EST 2006 | dougs
We've just set up a couple of products with 0.5mm pitch uBGA devices on them, i went for 5thou thick, laser cut nickel (to aid paste release) square pads same size as the diameter of the uBGA pads. Or you could go to a 4 thou nickel stencil, better
Electronics Forum | Mon May 15 15:42:29 EDT 2000 | Doug Smith
Can anyone tell me a recomended stencil apt. design for PBGA's and Ceramic BGA's when using a no clean (UP78) paste?
Electronics Forum | Wed Feb 05 14:20:45 EST 2003 | Stephen
One thing that worked for me was simply rounding off the pads, making square pads into circlesfor the stencil. It worked but did seem a little strange turning squares into circles for 0603's and 0402's and turning cirlces for BGA's into squares, (bu
Electronics Forum | Tue Feb 04 22:28:16 EST 2003 | davef
You could reduce the paste by about 70%. Solder balling and tombstoning will be the issues to fight. The drivers to these don't change with the component size. Use the fine SMTnet Archives for background. Aperture Size and Thickness of Solder Pas
Electronics Forum | Tue Oct 22 10:23:38 EDT 2002 | davef
ubga and stencil
Electronics Forum | Mon Oct 21 23:48:13 EDT 2002 | harris
Hi: If anyone have the experience with the PCB pad design and stencil design for the uBGA? We meet the problem for it. The component data is 0.3mm diameter and 0.5 pitch. Could anyone tell me the PCB pad dimension, the stencil type and aperture dimes
Electronics Forum | Mon Oct 13 13:49:29 EDT 2003 | mrmaint
Does anyone know of a standard stencil thickness for BGA'S. We currently use 4 to 5 mil stencils depending on component mix. Is an aperature reduction required for BGA'S. If so what percentage. Any help would be greatly appreciated. Thanks MRMAINT
Electronics Forum | Thu Sep 12 01:49:28 EDT 2002 | ck
Hi all, Any stencil opening recommendation for 20mils pitch mirco BGA. Currently, using 12mils round opening, 5 mils thickness. Seen to have weak joints as it crack after Ict testing. thks
Electronics Forum | Sun Oct 06 22:23:05 EDT 2002 | CH
Hi Eric, How to access to the Compaq Houston reprot. regds
