Electronics Forum | Sat Apr 12 04:07:21 EDT 2008 | sessioc
Good Point. Also, what about the type of solder paste your using - Are you getting a good release from the stencil? What do your boards look like after you print?
Electronics Forum | Thu Jul 28 07:23:24 EDT 2011 | scottp
My group supports a couple hundred lines all over the world. Most of them use squeegees but a few use either the MPM Rheometric pump heads or the DEK Proflow heads. I absolutely hate the enclosed heads. Flux separation, compaction, and the print q
Electronics Forum | Thu Feb 18 14:42:38 EST 2010 | djsmith1000
Hi everyone, First post here. I am completely new to smt as well. We are a small startup and would like improve our in-house smt assembly capability from manual assembly. We are looking at small production runs, initially about a total of 200 board
Electronics Forum | Fri Mar 29 10:11:02 EDT 2019 | cyber_wolf
“For a number of years now, work has been proceeding in order to bring perfection to the crudely conceived idea of a transmission that would not only supply inverse reactive current for use in unilateral phase detractors, but would also be capable of
Electronics Forum | Tue Jan 11 05:46:09 EST 2000 | Wolfgang Busko
Hi Dave, that was kind of a more rhetorical question. Normally paste is used before shelflife expires and delivery time is short enough to get in no trouble. The normal situation is that you try to get your equipment running means constant use of pas
Electronics Forum | Mon Jan 10 12:00:06 EST 2000 | Dave F
First, I agree with Wolfgang, in response to Wister. Second, Wolfgang: Sometimes, our blanket purchase order for paste schedules delivery of the paste in advance of production requirements. (What!!!???? In-bound material schedules don't match out-
Electronics Forum | Wed Feb 11 13:37:37 EST 2015 | cyber_wolf
I can buy approx 1000 stencils (cost includes next day delivery) for the price of a MY500. With a stencil, I can use WS paste and any other paste for that matter. The MY500 only jets certain paste from specific manufacturers. It is VERY VERY rare th
Electronics Forum | Wed Mar 14 11:24:32 EDT 2007 | Scotceltic
Have you thought about switching to either automatic paste dispensers or rhemoetric pumpheads in order to contain the paste and only dispense what is needed during your shift ? I am not sure what type of printers you have, but I know both of these o
Electronics Forum | Sun Mar 26 19:02:05 EST 2006 | ms
Hi We are running automatic stencil printers, open squeegees, stainless stencil, stainless blades, print speed 25-30mm/sec. We have a frustrating consistency issue printing .37x.3mm apertures on a 45pin LGA (11 pads each side, 1 large ground in mid
Electronics Forum | Mon Nov 07 07:43:56 EST 2005 | pjc
No way I've ever heard to remove mositure from solderpaste. What is the R.H. in your factory? Are you in the tropics? Does you printer have an enclosed print area like on an automatic machine, or is it semi-automatic and exposed to the room air?
