Electronics Forum | Tue Jun 20 21:30:05 EDT 2006 | davef
The minimum vertical hole fill is defined as follows: Class 1: Not specified, with a 270-degree circumferential fillet and wetting on the secondary (solder source side) of lead and barrel, and a 75% coverage of the land area on the secondary side. Cl
Electronics Forum | Mon Dec 03 10:47:11 EST 2007 | slthomas
I thought you said that the parts that weren't wetting in reflow were the parts with epoxy. The question I have is do they wet in wave solder, and if they do, why does it matter what happens to them in reflow? Conversely, if they don't wet in wave,
Electronics Forum | Tue Jul 01 17:15:03 EDT 2008 | ronhodgson
I would like an interpretation of a solder fillet on a 5 side termination cap. (Ref: IPC-610, sec. 8.2.2.6). My question pertains to the definition of dimension F, and what constitutes the top of the fillet. Does the top of the fillet end at where
Electronics Forum | Fri Dec 12 11:02:20 EST 2008 | patrickbruneel
Greg, I totally agree with you that machine settings are very important in wave soldering and soldering in general. I disagree that lead free alloys can produce wetting like in the attached picture (leaded alloy). Lead free alloys have a much higher
Electronics Forum | Thu Jun 27 17:32:35 EDT 2013 | tpost
We recently had a question come up regarding the amount of solder on a flat underside termination ( we referenced Flat Lug Lead in IPC 610). Judging by the photo you can see on the Left is a target solder joint, but on the right is one which had rewo
Electronics Forum | Fri Jul 24 16:33:45 EDT 2015 | cnotebaert
You should be fine! best practice for a situation like this would be to run a solder sample, either flux it and run through wave, or screen print, don't place parts and run through reflow. look for proper wetting characteristics if you see de-wetting
Electronics Forum | Thu Apr 20 03:50:35 EDT 2017 | cromaclear
To overcome the dewetting issues of the past, a number of techniques have been used such as alternating directions on the wetted nozzle; this helps to avoid the solder biasing to one side causing the other side to oxidize and de-wet. Another method o
Electronics Forum | Fri Aug 24 11:58:18 EDT 2018 | cupet
Hello davef, thank you for your reply. What do you think about the footprint for the diode on the first picture where the component is not assembled? There is good wetting on one pad of footprint and the other pad has bad wetting. This problem is not
Electronics Forum | Thu Feb 22 21:20:43 EST 2001 | davef
Sony assembly plants look like a Panasert sales person's wet dream.
Electronics Forum | Fri Oct 19 00:37:43 EDT 2001 | ianchan
Hi, my guys did such solder paste deposits on PCB bareboards before, (before my physical join with my current company), approximately 2-3 years ago, for a small Lot run. What the PCB supplier did was to apply "block" shaped Sn/Pb paste alloy onto t
