Electronics Forum | Thu Oct 26 17:48:47 EDT 2000 | Dave F
In response to your questions: 1) Suggestions on substrate material FR-4 or something better? Most PBGA are on BT. That might good for you, also. 2) Are there design guidelines for wire bonding pattern on the substrate? Several things: 1 Doesn�t
Electronics Forum | Mon Nov 15 14:40:38 EST 1999 | Bob Smith
Hi, I have a problem I've never seen before so I hope someone here can help. A recent batch of PCBs arrived where the copper lands delaminate with a small pull. Normally you have to pull pretty hard and the whole land comes off the substrate. These
Electronics Forum | Thu Jul 29 23:21:51 EDT 1999 | CH Lee
I received a request from customer to assemble ceramic substrate (alumina oxide)that printed with a low temperature Copper thick film conductor (the overglaze layer is polymer). The Copper pads are exposed without any coating. This ceramic substrate
Electronics Forum | Thu Jul 15 15:55:41 EDT 1999 | nards penalosa
| | We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec d
Electronics Forum | Thu Dec 24 02:17:22 EST 1998 | Chris Grendler
Anyone ever attach gold bump flip chip to FR4 or Alumina substrates. Am trying to find a solder which is acceptable for use on gold. Am worried about gold imbrittlement since the gold bumps on the flip chip are .004"x.004"x.001" solid gold. The pit
Electronics Forum | Thu Dec 24 09:32:53 EST 1998 | Earl Moon
| Anyone ever attach gold bump flip chip to FR4 or Alumina substrates. Am trying to find a solder which is acceptable for use on gold. Am worried about gold imbrittlement since the gold bumps on the flip chip are .004"x.004"x.001" solid gold. The p
Electronics Forum | Thu Dec 24 13:29:19 EST 1998 | Chris Grendler
| | Anyone ever attach gold bump flip chip to FR4 or Alumina substrates. Am trying to find a solder which is acceptable for use on gold. Am worried about gold imbrittlement since the gold bumps on the flip chip are .004"x.004"x.001" solid gold. The
Electronics Forum | Wed Oct 07 15:25:02 EDT 1998 | Joe P.
Hi Everybody | | Is anyone aware of the possible causes that may lead to voids in the solder bumps after assembly. We assembled some dice on thin substrates and after assembly, void formation in the solder bumps were observed. | We have alread
Electronics Forum | Wed Sep 09 21:20:26 EDT 1998 | Simon Ting
hi, 1206 capacitor with silver/palladium termination is mounted onto a ceramics substrates. Bonding is achieved through conductive epoxy. We discovered that the epoxy cracked and this caused missing capacitor. We had tried different grade of epoxy,
Electronics Forum | Mon Oct 19 17:43:12 EDT 1998 | John Gregory
Ryan - I noticed your comment concerning solid solder and was compeled to drop a note. We have developed a process which uses some material characteristics from earlier efforts with this technology and profiled it for flip chip and area array attach
.png)
