Electronics Forum | Mon Mar 27 12:48:12 EDT 2023 | assuredtech
Full Load Amp (FLA) ratings on a nameplate indicate that if you turned 100% of everything on all at the exact same time with the flip of a switch it would hit this FLA rating. Obviously, this would be bad and is not the reality of what happens. Each
Electronics Forum | Mon Sep 08 08:59:45 EDT 2008 | davef
You're correct: * Sealed relays should not be cracked or have moisture intrusion. * Hand soldering relays is going to be expensive. [Using a mini-solder pot for this might reduce some of the burden.] The good part is that the problem is gross enough
Electronics Forum | Mon Apr 13 14:36:18 EDT 2009 | leemeyer
I have seen this problem before. There is a cable that runs from the Quadalign board to the backside of the backplane. It is not secured in any way so it may have come loose in shipping. Open the right side panel on the machine. The Quadalign board
Electronics Forum | Mon Mar 27 12:58:09 EDT 2023 | spoiltforchoice
> Full Load Amp (FLA) ratings on a nameplate > indicate that if you turned 100% of everything on > all at the exact same time with the flip of a > switch it would hit this FLA rating. Obviously, > this would be bad and is not the r
Electronics Forum | Fri Apr 26 12:39:05 EDT 2013 | mmjm_1099
First started with having to replace the power supply in the computer. Once we did this now I am getting a "power failure detected" error on the screen as an alarm for the oven program. Anyone have some advice or input on this?
Electronics Forum | Fri Apr 26 15:00:44 EDT 2013 | leemeyer
This is what the manual says about this message : Power Failure Detected A main power failure occurred and the machine is being powered by the UPS. All heaters are shut off immediately ad the conveyor clears all boards If main power is not restored w
Electronics Forum | Tue Jan 27 21:46:53 EST 2015 | billnav
Does the DRS-24 rework station take single or three phase 208/240? Thanks in advance.
Electronics Forum | Thu Dec 01 13:35:21 EST 2016 | ttheis
I decided to replace the psu with three din supplies since it was a repeatable issue with the 5v rail. Machine is back in operation now with no signs of problems.
Electronics Forum | Sat Jul 24 06:00:50 EDT 2004 | zlatkon
I need to build regulated power supply 0-30V 0-20 Amps. The only solution possible for minimizing the thermal loss is to use triacs on the secondary Trafo side in order to cut the sine for low voltage output and great current. (like 5V, 20A). Please
Electronics Forum | Tue Nov 29 11:45:35 EST 2016 | ttheis
I was able to repair the original power supply for the printer again with parts from another similar power supply on ebay. At first the machine didn't power up properly even though the supply voltages were all good on a volt meter when tested befor
Manufacturer of PCB depaneling and PCB soldering machines since 2005, products include CE approval V-groove PCB depanelizer, PCB router, PCB punching machine, laser depaneling, hot bar soldering machines and soldering robots.
Liwu Industrial Park, Yuanzhou Town, Boluo
Huizhou, 30 China
Phone: +86-138-29839112