Electronics Forum | Thu Dec 23 15:10:50 EST 1999 | Victor Salazar
What we did was design or panels with routed out edges held on by tabs. This was very effective. All we use is a pair of pneumatic scissors to cut off the tabs. We are using from single-to 13 layer PCB's and we have had no problems with delamination
Electronics Forum | Thu Feb 01 15:38:05 EST 2001 | camohn
Is anyone presently using a laser in depaneling their PCB's? What OEM's equipment are you using? What advice would you give regarding laser cutting pcb?
Electronics Forum | Mon Nov 23 19:20:18 EST 1998 | Kevin
A buddy of mine has problems after depaneling double sided pre-scored PCB's. Resistors near the edge, after put into the slice and dice machine contain micro cracks. He's checked for them before and after depaneling. We figure it is the sectioning
Electronics Forum | Wed Nov 25 12:33:16 EST 1998 | Scott Snider
| A buddy of mine has problems after depaneling double sided pre-scored PCB's. Resistors near the edge, after put into the slice and dice machine contain micro cracks. He's checked for them before and after depaneling. We figure it is the sectioni
Electronics Forum | Fri Dec 24 10:51:29 EST 1999 | Bob S
If you have decent volume with high mix or are a contract shop, the most flexible method is a software controlled router. Using pre routed boards with tabs is not a bad way to go but there is a price for the pre routing that may more than justify the
Electronics Forum | Wed Nov 29 08:55:35 EST 2017 | capse
I represent Fancort Industries. We provide "pizza cutter" and horizontal opposing blade "guillotine" style v-score depanel equipment. The edge clearance requirements are 0.030" - 0.050" for the wheel cutter and down to 0.020" for the opposing blade e
Electronics Forum | Tue Nov 24 11:13:11 EST 1998 | Keith
| A buddy of mine has problems after depaneling double sided pre-scored PCB's. Resistors near the edge, after put into the slice and dice machine contain micro cracks. He's checked for them before and after depaneling. We figure it is the sectioni
Electronics Forum | Tue Nov 24 13:51:23 EST 1998 | Michael Allen
What kind of "slice and dice machine" do you use? I assume you're referring to what I call a score-breaker -- a device to separate the board from the panel (or from the adjacent board) by crushing the score-line WITHOUT bending the panel or the boar
Electronics Forum | Tue Nov 28 13:43:48 EST 2017 | emeto
I have half of that distance.
Electronics Forum | Tue Nov 28 13:23:34 EST 2017 | georgetruitt
For connectors, we maintain a 0.05" clearance from components edge to the center of the V-groove score
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
