Electronics Forum | Wed Oct 03 23:59:44 EDT 2018 | gaintstar
Flason SMT problem solving: http://www.flason-smt.com/new/PRINCIPLE-OF-SURFACE-MOUNT-PROCESS-SMT-PROCESS.html http://www.flason-smt.com/new/Printed-Circuit-Board-PCB-Price-Estimator.html http://www.flason-smt.com/new/Printed-Circuit-Board-Solder-res
Electronics Forum | Fri Sep 21 14:03:45 EDT 2001 | jschake
I have observed solder balling for all aperture sizes tested. Solder balling levels appear to be better correlated against the amount of solder paste that is underneath the 0201 component terminations after placement rather than comparing this to th
Electronics Forum | Tue Sep 22 12:25:31 EDT 1998 | Chrys
| | Hi Jacqueline! | | Do these joints that you're having problems with happen to be on fine pitch solder joints? Are the fillets staying attached to the foot and separating from the pads cleanly? | | If that is true, are there many vias concen
Electronics Forum | Thu Dec 16 20:55:09 EST 1999 | TNT
Hey Henry, Tombstoning can result from many different conditions: 1. Look at the part placement under a microscope before the board has been reflowed. Is it centered perfectly on the pads? If not, the part might migrate towards one pad during reflow
Electronics Forum | Fri Jul 21 03:51:06 EDT 2006 | Rob
Hi CKH, Here's some things to consider: 1) Moved by obstruction in/entering oven, such as nitrogen skirts 2) Incorrect air pressure/air leak in oven (large surface area on component) 3) Reflow temperature too hot & electrolyte/air in cap is expandi
Electronics Forum | Fri Apr 17 10:44:29 EDT 2009 | rmitchell
Hi, follow up, Thanks to everyone that responded. We finished the build, the sun burst thru the clouds and the birds sang. Well that was a slight exageration. Sorry for lack of detail on the original post, I was frazzled. Since the 0201's were p
Electronics Forum | Wed Jun 03 22:07:41 EDT 2009 | davef
= 0.66 aperture opening to the stencil wall has been shown to provide the best transfer efficiency and repeatability of the deposited paste. Values from 0.66 to 0.8 insure a good paste release from the stencil. The biggest impact on area ratio is the
Electronics Forum | Mon Jan 23 22:53:31 EST 2012 | davef
= 0.66 aperture opening to the stencil wall has been shown to provide the best transfer efficiency and repeatability of the deposited paste. Values from 0.66 to 0.8 insure a good paste release from the stencil. The biggest impact on area ratio is the
Electronics Forum | Wed Dec 15 12:50:39 EST 2010 | hegemon
We evaluated Vapor Phase Reflow in 2010, and in the short time I experienced the machine, I came away with the following. The advantages you are (hopefully)already aware of, such as overall tranfer of heat to the PCB, no chance of temperature oversh
Electronics Forum | Mon Nov 05 16:54:00 EST 2007 | bbarton
There are several things that can be done to increase throughput on you screen printer, including the panelization of your bords as Steve & Hussman has pointed out. However that's of limited use if you have plenty of stock that is not panelized. That
