Electronics Forum | Tue Sep 06 15:18:01 EDT 2011 | tdhiggins
Mike, I can send you a copy. What is your email > address? Travis, I could use a copy of the manual or parts and pieces of it. Could you send me what you have? tdhiggins@spectek.com thanks, Todd Higgins
Electronics Forum | Wed Dec 08 17:48:18 EST 2010 | katguts69
looking for schematics for electrovert omni 7 reflow oven. manufactured in 1998. help!
Electronics Forum | Thu Dec 09 12:31:39 EST 2010 | travishemen
Mike, I can send you a copy. What is your email address?
Electronics Forum | Wed Sep 11 17:16:17 EDT 2013 | saied
Hello, We would like to order this spare-part blower motor electrovert omni Excel for Speedline Technologies Electrovert, type: Omni Excel 7 Serial: 476219 Date: 4/04 and we would be thankful if you provide us the Service manul for your prod
Electronics Forum | Mon Sep 28 14:27:08 EDT 2009 | soudomphong
I need help with conveyor speed in Omni Excel 7. It fluctuate, and never have a steady speed. I swapped the speed control card,calibrated, encoder, and I still have the same problem. Any help would be appreciated, thanks.
Electronics Forum | Thu Apr 06 16:08:17 EDT 2023 | jdengler
Thanks for the effort. I have the maintenance and operations manuals in PDF so they are not missing. It looks like the only place it will show which SSR controls which heater will be in the schematic.
Electronics Forum | Tue Jul 04 01:35:01 EDT 2023 | sophyluo1985
SMT friends, I need your help. Does anyone have the MIRTEC MV-7 OMNI 3D-AOI operation manual? Please send me a copy to quinnsmt@gmail.com. thank you all
Electronics Forum | Thu Feb 10 16:45:36 EST 2005 | pjc
It all depends on what type of board you need to solder. If your boards are small in size and low thermal mass and your conveyor speed requirments are normal, then I'd say the OmniFlo 7 will do the job. It has a max zone temp setting of 280C. The cur
Electronics Forum | Thu Oct 25 10:05:05 EDT 2012 | kz9yyc
Hello all, I am having difficulty with an OmniExcel 10 oven. Zone 5 upper will not hold setpoint = 165C (it typically runs ~10C higher). Here is what I know: 1. The machine is not turning on zone 5 heat when temp is too high. 2. Zone 5 lower is
Electronics Forum | Mon Jun 19 22:19:40 EDT 2006 | Nathan
Dear All, We plan to setup an assembly line for our small volume production of PCBs (about couple hundred PCBs per week). The board has about 150 components (less than 30 types) and a few BGA and IC (majority is SMT, only few THT connectors). We hav
