Electronics Forum | Tue Nov 18 07:22:56 EST 2008 | wewilldoit
Hi folks! TI told us that we are the only one with the following problem... We discovered a really bad wetting characteristic of some SMD ICs from BurrBrown. At the moment: XTR106 / INA118 / ADS7844. After the reflow process we found out that this pa
Electronics Forum | Wed Jan 16 12:04:45 EST 2002 | dason_c
You can use the IPC-7525, Stencil Design Guidelines for start up.
Electronics Forum | Wed Jan 16 11:20:52 EST 2002 | bentzen
Hi... We tend to do a lot of footprint calculating for new SMD components. But what about the amount of solder paste on the solder pads. The amount of solder alloy is of cause determined by the stencil aperture size, stencil thickness and the sold
Electronics Forum | Wed Jan 16 20:06:09 EST 2002 | davef
No, not as such. Consider: * Using the IPC calculator [free at http://www.ipc.org]. It allows you to consider / assess the amount of solder when designing pads. * Reviewing IPC-7525 - Stencil Design Guidelines. It gives general aperture guidelines.
Electronics Forum | Tue Dec 14 10:36:42 EST 1999 | Paul Peterson
I recently encountered reflow soldering defects on a pair diode package, the smd pad had a green contamination, I'm convinced that this is not oxidation. The no-solder condition appears to be caused by a sloppy soldermask process, although over the y
Electronics Forum | Mon Jun 12 22:00:51 EDT 2000 | Dave F
Could be. What are your profiles? 2) Au finish fail => Could be, but that the connections can be made with hand soldering makes this a low probability cause, assuming the activity of the flux used in hand soldering is not significantly different fr
Electronics Forum | Wed Jan 16 15:22:29 EST 2002 | Terry Burnette
In his book titled "Manufacturing Techniques for Surface Mount Assemblies" author R.J. Klein Wassink describes the relationship between solder land dimensions, component lead coplanarity, board warpage, solder volumes, and solder paste flux wetting b
Electronics Forum | Fri Feb 20 08:44:05 EST 2004 | davef
Lucky guess, eh? [Sorry to blow your theory on bad parts] A 1000 of these boards on the line, ummm. Two ideas to consider: * Increase the conveyor angle [don't get carried away, just keep the angle below 8*]. * Balance the flow of solder so that th
Electronics Forum | Tue Feb 03 06:52:45 EST 2004 | paul_bmc
About 2 years ago our company tried to go with a post reflow AOI inspection. This AOI was suppose to be able to inspect to a level class 3 product. **It is impossible** You cannot inspect for a heel fillet and inspecting for poor wetting is a very
