Electronics Forum | Wed Sep 01 05:25:34 EDT 2004 | Martin
Hello, I am looking for some advice please about how to go about plating some brass pins for a new assembly. (which will be hand soldered) I have spoken to a couple of "experts" who seem to contradict themselves.. Firstly what should I be solderin
Electronics Forum | Mon Nov 25 09:06:15 EST 2002 | jax
You might want to check the tin thickness. I believe you have a minimum of .65 microns in order to achieve a good solder joint through 3 thermal passes. In an immersion tin process, the ability to solder is time and temperature dependant. As the int
Electronics Forum | Mon Dec 20 21:01:12 EST 2004 | davef
Bare inconel is NOT ment to take solder, because * Nickel develops a tenacious oxide layer that is very difficult to remove since the nature of the oxide is very dense, coherent, etc. * Chromium is difficult to solder. * Iron is difficult to solder.
Electronics Forum | Fri Oct 09 13:37:55 EDT 2009 | tstrat
We are seeing similar issues. We have a board that consistently has failures on a BGA part. After SEM/EDS it was shown that the fractures were occurring between the Ni-P and Ni-Sn intermetallic in the ENIG finish. The element map showed elevated conc
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Fri Mar 14 15:14:31 EDT 2008 | samir
Dean, thanks for schooling me on this. I talked to an industry collegue whom I met at APEX, and it was he who had told me of the IAg "rework issue." Basically, he told me that they had field failures on QFPs that were a direct result of trying to "
Electronics Forum | Thu Aug 20 15:10:21 EDT 2009 | davef
Responding to your points: * The intermettalic layers [ie, Cu6Sn5, Cu3Sn] between the solder and the copper pad is the same composition with both lead free and leaded solder. The lead in solder has no impact on the intermetallic. * As you say, increa
Electronics Forum | Tue Dec 01 07:24:44 EST 1998 | Earl Moon
| Hi folks , | Lately we are seeing a lot of rawcards with black spots on the pads - most of them have Au finish(immersion gold) . We did a lot of inspecton after wave solder and found that only (fine pitch) QFP are affected the most. Our inspection