Electronics Forum | Wed Jul 22 22:19:07 EDT 2020 | kghadiya
Hello Experts, I am using Heller 1707EXL in my shop. From last 2 months I have faced component missing and flying problem. I tried everything to figure out the problem i.e. change solder paste, re-calibrate PnP machine, several oven recipe etc but s
Electronics Forum | Thu Jul 23 06:15:33 EDT 2020 | bukas
There is a oven setup wizard on my 1809. your oven probably has one too. there you should be able to adjust blower speed for each zone.
Electronics Forum | Thu Jul 23 13:44:50 EDT 2020 | dwl
I used to have the same issue with reed switches on one product we ran. Same oven too. We ended up rigging up an "umbrella" with two titanium stiffeners and bare PCB as the roof. It was hokey but it worked.
Electronics Forum | Thu Jul 23 13:23:45 EDT 2020 | bmalhi
Small components blown issue could be due to one of the below. - Process issue; Make sure solder paste is fresh, if flux is drying out it will not hold parts properly. Check downward pressure of Pick Place. SOT may have to be pushed a little harder i
Electronics Forum | Mon Sep 10 09:49:11 EDT 2012 | dyoungquist
We have a Heller 1707EXL that we purchased in 2006. During the first year we had 2 blower motors go bad. After the second one went bad, Heller sent a technician who replaced every blower motor on the oven at their expense. Since then it has been 5+
Electronics Forum | Fri Sep 07 16:53:37 EDT 2012 | burb1999
We have Heller, 1707EXL now. It has a removable support for the mesh conveyor that just pull out (clipped in). Had an Electrovert and they were bolted on and very tuff to change out. The oilers Im not sure I care for though,they have a metal rail t
Electronics Forum | Fri Sep 16 19:46:55 EDT 2011 | jlawson
I have seen this on Heller1707 machines also for LED devices. The same job was run on anthoer brand oven (Rehm) and no issue. I think Heller Blower velocity can be a little on higher side as is a low inertia heating system and they have to make up f
Electronics Forum | Fri Sep 16 14:12:23 EDT 2011 | jtownsend
Anyone have experience or advice to help prevent SMT reed switches from being blow out of position during re-flow? We are using a Heller 1707 MK 3. Is it possible to adjust air flow in the oven or do we need to glue before placement??
Electronics Forum | Tue Jul 30 03:57:29 EDT 2019 | SMTA-David
Hi, I am looking for software for 2003 model 1707 EXL reflow oven (HC1 controller). I believe latest version for that model is 1.0.6.5.8 (98 Win) or 4.0.2.1 for XP. Thanks
Electronics Forum | Tue May 19 13:29:33 EDT 2015 | dyoungquist
We have been running a Heller 1707EXL for 8 years and added a Heller 1707MKIII about 1 years ago. We have not had any problems with either one of them. We do both lead and lead-free assemblies along with BGA/LGA components. If speed/volume is not
Reflow ovens for automated SMT PCB assembly, specializing in lead free processing and nitrogen reflow. The best convection reflow ovens on the market.
4 Vreeland Rd.
Florham Park, NJ USA
Phone: 973-377-6800
