Unknown machine

Subscribe to Thread

HI! Does anybody know driller/miller called "Direct Imaging ... - Sep 12, 2005 by

> HI! Does anybody know driller/miller called > "Dir... - Sep 16, 2005 by

That machine came to us about 5-7 years ago! I'm trying to m... - Sep 26, 2005 by Jari S

Jari

#36613

Unknown machine | 12 September, 2005

HI! Does anybody know driller/miller called "Direct Imaging System II"? I have one, but its not working properly. I think that there is some corruption in software. All kinds of information about this machine is welcome: manuals, software, other users, contacts, etc.

reply »

Randy

#36693

Unknown machine | 16 September, 2005

> HI! Does anybody know driller/miller called > "Direct Imaging System II"? I have one, but its > not working properly. I think that there is some > corruption in software. All kinds of information > about this machine is welcome: manuals, software, > other users, contacts, etc.

I have most components of a system. Have you ever used yours?

Randy

reply »

Jari S

#36844

Unknown machine | 26 September, 2005

That machine came to us about 5-7 years ago! I'm trying to make it working again, but I need someone who knows something about it. I think that machine works well. Its as good as new, but i'm not sure about the software.

When I try to run drill table, it moves at the center of table and lowers the bit. After that nothing happens...

Resetting the driller is the only way to contact it.

reply »