Calibration problem FUJI NXT III

Subscribe to Thread

Good morning, After the visit of an external technician due ... - Apr 17, 2024 by acouto

I have a AIMEX III and we have seen the top cover on the con... - Apr 17, 2024 by jdengler

Yes, it is the same type, the problem only happened after th... - Apr 17, 2024 by acouto

Can I ask a question? ... - Apr 29, 2024 by Jordan Haynes

? ... - Apr 29, 2024 by acouto

acouto

#90876

Calibration problem FUJI NXT III | 17 April, 2024

Good morning, After the visit of an external technician due to the change of cables, when resetting the camera mark again when doing the inspection fails to check the calibration points of the conveyor. Is it possible that the technician has decalibrated the light/mirror of the mark camera? What can be done to repair it? I've already replaced the mark camera with a new one but the problem remains.

reply »

jdengler

#90878

Calibration problem FUJI NXT III | 17 April, 2024

I have a AIMEX III and we have seen the top cover on the conveyor being pushed out of postion when someone does maintenance. I beleive the NXT's use the same configuration. Check to see that the cover is pushed all the way over where the PCB would be located during production.

reply »

acouto

#90881

Calibration problem FUJI NXT III | 17 April, 2024

Yes, it is the same type, the problem only happened after the technician removed the mark camera and the light. The manual states that you should not move the mark camera light with your hands. So I think I may have miscalibrated the equipment in some way.

reply »

Jordan Haynes

#90912

Calibration problem FUJI NXT III | today at 12:54 PM

Can I ask a question?

reply »

acouto

#90914

Calibration problem FUJI NXT III | today at 05:03 PM

reply »