Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Filter full occurred error coming at every autochanger over in NPM machines

Views: 5887

#90690

Filter full occurred error coming at every autochanger over in NPM machines | 13 March, 2024

#90734

Filter full occurred error coming at every autochanger over in NPM machines | 20 March, 2024

Vacuum Low, Shows up on changeover when the head picks a different size nozzle, remove mesh filter, unplug the clear pipe from the top of the head, put a small amount of alcohol down the pipe and blow it out with the air gun, You should check for a hole in the vacuum pipe, Squeeze the pipe turn on vacuum, (Vacuum level reading should drop to zero),

reply »

#90783

Filter full occurred error coming at every autochanger over in NPM machines | 28 March, 2024

After cleaning also same issue

reply »

#90789

Filter full occurred error coming at every autochanger over in NPM machines | 28 March, 2024

replace flow, vacuum sensor

reply »

#90791

Filter full occurred error coming at every autochanger over in NPM machines | 28 March, 2024

What type head is it? Try changing the internal filters. If it is a low number head, ie: 1-4 on an 8, 1-6 on a 12 or 1-8 on a 16. These can be accessed by pushing the head to the opposite table for removal. Chapter 11, section 11-6 page 11-6.3 in maintenance manual for 16. 12 Nozzle and 8 are the subsequent sections. If they are the high numbered nozzles, the head has to come off for access.

reply »

#90794

Filter full occurred error coming at every autochanger over in NPM machines | 1 April, 2024

Get the Cisco Catalyst 4500 series switches at affordable prices and save up to 80% with free shipping. Avail best offers on new and refurbished Cisco products with free shipping.

reply »

Manufacturing Software

SMT spare parts - Qinyi Electronics