| Certain ICs cannot be place by our pick and place machines and therefore operators place them by hand. Has anyone seen some type of dispensing material handler that would ensure we don't bend the leads of this fragile devices? I'm envisioning some sort of apparatus where the tubes feed in from the top and one component can be removed at a time. Any suggestions would be greatly appreciated. | Hi Lauren, having started with handassembly of SMD I mounted my old manipulator ( it was a Fritsch manipulator ) to a transportationconveyer ( three-belt-system with a stop funktion ) between the placer and the reflow so we could use all kinds of feedersystems that matched from the rear and also had the advantage of adequate componenthandling. Same thing I recommended some sites with the same problem and although they had to buy some equipment ( they got themselfs used ones ) they now consider this a good solution. Luckily we have around here ( Hamburg/ Germany )a shop that customizes equipment the way you need it for almost no extracharge cause every item they sell is build on demand. You�ld be lucky if you find a similar shop in your region.
greetings from the present romantic misty harbour of Hamburg
Wolfgang
reply »