Question on how to save the board image along with the results on Mirtec MV-3U after inspection is complete

Subscribe to Thread

We have a Mirtec MV-3U AOI machine. Can someone help me to f... - Dec 09, 2022 by Varun Bhardwaj

Its ether going to be in the settings before launching the s... - Oct 03, 2023 by OptoGuillermo

Varun Bhardwaj

#88701

Question on how to save the board image along with the results on Mirtec MV-3U after inspection is complete | 9 December, 2022

We have a Mirtec MV-3U AOI machine. Can someone help me to find a way on how to save the image of the board along with the report after the inspection is complete? Currently it only saves the report with the errors showing on the template image which it is trained on.

reply »

OptoGuillermo

#90034

Question on how to save the board image along with the results on Mirtec MV-3U after inspection is complete | 3 October, 2023

Its ether going to be in the settings before launching the software at the login screen or the settings after launching the softer on the top right. You should see some tab relating to defects. There should be a setting that says something along the lines of save defective part images.

reply »