Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 6133
Got a failure while starting up our GSM, and hoping you guys... - Oct 09, 2014 by robgd3
First, plug all holes with nozzles or plugs. Then use I/O di... - Oct 10, 2014 by Deni
Deni, Thanks. I managed to do pretty much exactly that. ... - Oct 13, 2014 by robgd3
Check in Machine setup -> parameters -> axis that z axis for... - Oct 13, 2014 by Deni
Deni, Yep, we found that one the other day, too. And, ye... - Oct 13, 2014 by robgd3
So...today, we were able to get rid of the z axis not mounte... - Oct 13, 2014 by robgd3
Hey rob, make sure you do the changer setup. That procedure ... - Oct 13, 2014 by Tushar
Z axis drivers are located in co-salled LP servo bay. It is ... - Oct 14, 2014 by Deni
Thanks, Deni, I discovered the servo control box, but, no... - Oct 14, 2014 by robgd3
Thanks, Tushar, we might give that a try. The only reason... - Oct 14, 2014 by robgd3
Deni, Do you know if the theta axis controlled by the sam... - Oct 14, 2014 by robgd3
No, each card in LP servo rack drives only one motor. But th... - Oct 14, 2014 by Deni
The axis drive cards can be swapped, so if you switch the se... - Oct 14, 2014 by Comatose
Just be careful to set the jumpers accordingly, if you swap ... - Oct 14, 2014 by Deni
Had someone in from the broker that we bought this machine f... - Oct 20, 2014 by robgd3
Progress!! Somehow, this morning I was able to get things... - Oct 20, 2014 by robgd3
Hi Rob, We have a GSM2. We have had that error in several... - Oct 23, 2014 by george
Thanks, George. Yep, we got through all of that. Then we... - Oct 23, 2014 by robgd3