Electronics Forum | Mon May 18 08:59:41 EDT 2009 | ozgurv
Dear All, Does anyone on the forum have experience with underfilling process of bga? We have a component with 0.5mm bga on one of the new products. Customer wants this component to have an underfill. Questions - 1) which kind of epoxy or chemica
Electronics Forum | Fri Mar 19 10:06:22 EDT 2010 | karlo
Rework is typically done by heating the BGA to 170-180C to first scrape off the fillet. Then, heat to above reflow, and lift the BGA. Then, collapse the solder with heat and flux. Then, back down at 170-180C, scrape off the underfill from the boar
Electronics Forum | Tue Nov 14 11:38:44 EST 2000 | Jacqueline Coia
Hi there, Making a request here, Does anyone out there in Scotland know of any company that has a 'SRT' BGA rework machine??? ta Jack
Electronics Forum | Thu Sep 12 01:49:28 EDT 2002 | ck
Hi all, Any stencil opening recommendation for 20mils pitch mirco BGA. Currently, using 12mils round opening, 5 mils thickness. Seen to have weak joints as it crack after Ict testing. thks
Electronics Forum | Wed Oct 02 15:08:37 EDT 2002 | Eric
See Fiske first line. I'd bet You are bending or catching the assembly in the ICT. How many probes at 8OZ each? do you use on that ICT? 800 probes = 400lbs. See "Flexure induced failure of BGA solder joints" by Compaq Houston TX
Electronics Forum | Mon Oct 13 19:04:47 EDT 2003 | davef
Aperture size should vary with the component [pitch]. That size should be the same a the pad size. So, generally pinching is not required. Indium discusses BGA apertures on their site [ http://www.indium.com ]
Electronics Forum | Tue Mar 09 09:22:40 EST 2004 | Tobias
Hello, i'm searching for a way to remove bga's easy and cost effective. It doesn't matter if the PCB or adjacent assemblies are damaged. Thanks!
Electronics Forum | Tue Mar 09 17:41:24 EST 2004 | davef
Try this: * Run the board through your reflow oven set for a "normal" recipe, but with the cooling section turned off. * Pick the BGA from the board while the solder is still liquid using tweezers [or similar tool].
Electronics Forum | Mon Jul 12 13:02:38 EDT 2004 | jasont
anybody doing bga placement w/Fuji IP2? what is required if it is possible (camera, nozzles, s/w, etc.), thanks
A US manufacturer of quality hand tools for those engaged in the repair, rework, R & D, testing, and assembly of electronic components and printed circuit boards from Through Hole to 2Mil Pitch Surface Mount.
98 Elm St.
Portland, ME USA
Phone: 1-207-775-6139
