Electronics Forum | Tue May 17 11:24:52 EDT 2005 | ricardof
We don't shut the machines down, we keep them working, however,sometimes the AC supply gets down because of a storm so we have a Forced shut down, as someone said, if we shut equipment down on every storm that represents $$ millions $$. The bad thing
Electronics Forum | Tue Oct 12 22:33:41 EDT 1999 | Clifford Peaslee
Hello SMTneters, We will be shutting down the forum temporarily while we switch over the existing forum to the new and improved version. The switch over will happen from 11pm to 1am est. Thanks, Cliff
Electronics Forum | Sun Dec 04 15:42:21 EST 2011 | ngineer
Thanks for the reply bobpan. I had the motor power on. I did have a side panel that was not shut all the way. Once I shut that, the error went away and it made it through its startup sequence. No errors. Thanks for the help.
Electronics Forum | Mon Oct 15 09:55:50 EDT 2012 | anvil1021
These microvias were plated shut? Could there have been some out gassing of these plated shut areas during reflow? I agree with your void % assesment unfortunately my Superiors do not... Thank you for the input.....anvil
Electronics Forum | Thu Oct 26 07:18:47 EDT 2017 | stephendo
Once upon a time an IP3 and CP6 would shut themselves off when the room was too hot. But IIRC they simply shut down until they cooled off.
Electronics Forum | Wed Dec 25 19:27:57 EST 2002 | MA/NY DDave
Hi Hope a few others give you applicable experience to your question. I never had a real long shut down, yet have experienced short shut down problems. I would run it in the best cleaner you have in your shop before you shut down for a long spell,
Electronics Forum | Wed May 11 11:21:11 EDT 2005 | russ
Been getting wacked by lightning for twenty years in this business. (three times yesterday as a matter of fact) We have never shut down in anticipation that we are going to get hit. I have lost one motherboard in all of these years that cost about $
Electronics Forum | Mon Oct 17 12:36:34 EDT 2005 | ratsalad
UTZ shut down their west coast office. When you call there, you are redirected to New Joisey.
Electronics Forum | Fri May 04 05:26:20 EDT 2012 | mrross
We do this If you shut down without cooling first it could warp the chain
Electronics Forum | Tue May 07 14:54:38 EDT 2013 | shankar2013
Tried High and highest. Same message on shut down
