Electronics Forum | Mon Jun 01 18:54:58 EDT 2015 | frix
Good day, I've got a situation with a Siemens 80S15. Everything used to work fine. One day when I switch the machine on the star (12 segment star in the head) just keeps on running when a head reference is commanded in SiTest. Can somebody please g
Electronics Forum | Thu Jun 04 07:54:53 EDT 2015 | frix
Good day, Thank you very much for the response. We are currently running 0603 and larger. I don't think there is any components that got into the head. I've been reluctant to open up the glass encoder of the head - it seems that a lot of the parts
Electronics Forum | Sat May 04 11:24:08 EDT 2013 | amelby
Hi, I have been having a problem with my My19E's hydra. The machine comes up with an error "Failed to locate HYDRA tool reference marks" and stops running. It does not happen for about the first two hours of running. It starts to happen after that an
Electronics Forum | Mon May 06 11:16:07 EDT 2013 | rdubya
if you don't have anything obstructing the camera then it sounds like it could be the camera power supply going bad. what version of tpsys are you running?
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Mon Mar 29 12:33:48 EST 2004 | masr
Mark, I have almost 10 years of experince with Siemens equipment but I don't understand your question, what tooling you refering about, you mean reference run?
Electronics Forum | Thu Jul 27 17:18:43 EDT 2006 | seth
Yes, I have but if I don't then I won't be able to reference run.
Electronics Forum | Thu Feb 15 00:09:59 EST 2024 | erici
Does anybody know how to disable the RV head on a Siplace F5 machine. Our machine is configured with a 6-head RV head and an IC head. We are having problems with the RV head, and machine wont initialise without finishing the RV head reference run.
Electronics Forum | Mon Aug 27 10:17:25 EDT 2007 | Smartens
We bought a used Siemens (thus we have no factory support just yet...) and have run into a bit of a "catch 22" situation. We got an "General Error :694 Incorrect nozzle length" and in the past this had to do with having a defective nozzle on the sle
Electronics Forum | Thu Feb 15 20:16:59 EST 2024 | erici
thanks for the reply. The Step motor module at the head is defective, so when the machine does the reference run, it will give a timeout because the DP station and pick and reject stations are not working. I reckon if i disable the RV, maybe i can
