Electronics Forum | Wed Apr 18 17:21:17 EDT 2018 | emeto
Are you designing a PCB or you are going to manufacture someone else's board?
Electronics Forum | Sun Nov 14 21:46:54 EST 1999 | Tuan Nguyen
I would like to know all the information about PCB assembly cost analysis. Anyone who has the information or know the source, please show me. I am very preciate about it.. The information can be Software, book, magazines, forum, and technical docu
Electronics Forum | Tue Nov 30 11:05:37 EST 1999 | Bob Smith
Hi, Can anyone give me the name & address etc. of a lab that will section PCBs and analyze defects? Thanks. Bob
Electronics Forum | Tue Nov 30 16:53:57 EST 1999 | Dave F
Bob: consider two thing: 1 Most board fabs have PCB sectioning capabilities 2 Consultants Council Matrix (http://www.ipc.org/html/fsresources.htm) lists consultants that may be able to help you. Ta Dave F
Electronics Forum | Sun Dec 05 22:51:56 EST 1999 | dreamsniper
Just contact any PCB fab near your area/country or wherever your manufacturing site is located and ask them if they could help you with your problems...they should be able to do that...
Electronics Forum | Tue Nov 30 11:43:02 EST 1999 | Wolfgang Busko
Where should this lab be, means where�s your place, you wouldn�t like to send your boards elsewhere on earth? Wolfgang
Electronics Forum | Tue Nov 30 16:14:27 EST 1999 | Glenn Robertson
Bob - Try John Maxwell at (719) 687-6911. I have seen him do some presentations at the trade shows. Glenn Robertson
Electronics Forum | Mon Nov 15 13:38:35 EST 1999 | Dave F
Tuan: Many people develop spreadsheets to represent their processes and costs. Also, check out CostCoach at http://www.costcoach.com, it may be just what you need. It was developed by Phil Zarrow, Ron Lasky of MPM, Dr. Dan Baldwin of Georgia Tech a
Electronics Forum | Mon Aug 07 09:58:41 EDT 2006 | nodlac
Davef's link is a great one. Mine pales but may be helpful... - This one is from Georgia Tech on Yield... http://www.cbar.gatech.edu/about/publications/Analysis%20of%20Factors%20that%20Affect%20Yield%20in%20SMT%20Assembly.pdf - http://www.cbar.marc
Electronics Forum | Wed Aug 22 12:44:26 EDT 2012 | rway
I would look at your de-paneling process. How are you cutting the boards? This could be inducing mechanical stress on the component; especially if the part is close to the edge of the pcb and perpendicular to it.
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
